F9E1 displayed; oven door will not lock or unlock during self-clean.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Failed latch motor, open latch motor wiring, seized latch mechanism, failed control latch relay

Safety: Disconnect power before accessing the latch. Beware of sharp edges.

Listen for motor: Attempt to start a self-clean cycle briefly and listen for latch motor noise. If none, suspect motor or wiring.
Inspect latch assembly: Remove top or rear panel to access latch. Check for binding or mechanical obstruction.
Test motor: With a meter, test the latch motor for continuity. Replace the latch assembly if open or seized.
Control issue: If the motor is good but not receiving voltage when commanded, the control board may be defective.

Hard 4/5

Oven Door Latch Motor Assembly

Check Price on Amazon

We may earn a commission from links on this page.