Induction hob shows a single 'E' on one zone display and that zone does not heat.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Unsuitable cookware, Pan too small or off‑center, Temporary electronics glitch, Faulty zone electronics on power module

Note: A single 'E' is often a non‑specific error related to the affected zone.

Check cookware: Use a flat, induction‑compatible pan of adequate size and center it on the zone.
Clean surface: Remove any spills or residues under the pan that might affect detection.
Power reset: Turn off the hob at the mains for 5–10 minutes, then restore power and test the zone again.
If only one zone always shows 'E': The zone electronics on the power module may be faulty. A technician should test and replace the relevant module.

Medium 3/5

Induction Power Module (Zone Channel)

Check Price on Amazon

We may earn a commission from links on this page.