E0
Summit
Control Board Communication or Configuration Error
Cooktop or range control displays E0 and surface elements may not respond.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Loose harness connection to user interface, Incorrect configuration jumper on control, Control board firmware fault, Power surge damage
How to Fix / Troubleshooting
Safety first: Disconnect power before removing any panels.
- Power reset: Turn the breaker off for 5 minutes, then restore power and check if E0 clears.
- Check harness: Remove the control panel or front bezel on your Summit cooktop/range. Inspect the wiring harness between the display board and main control. Reseat all connectors firmly.
- Configuration check: Some Summit controls use jumpers or DIP switches for model configuration. Verify they match the service manual for your model.
- Replace control: If E0 persists and wiring is intact, replace the main control board or user interface board as specified in the service documentation.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements