E18
Segway Main Control Board Fault

Mower displays E18; internal self‑test reports main board error.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Failed power regulator on main PCB, Burned motor driver IC, Corrosion from moisture ingress, Firmware corruption

How to Fix / Troubleshooting

Safety first: Disconnect the battery and charger before opening the electronics compartment. Static discharge precautions are recommended.

  • Visual inspection: Remove the main board cover and inspect for burn marks, corrosion, or obvious component damage.
  • Check for moisture: If condensation or water is present, dry the area thoroughly and identify the source of ingress (damaged seals, cracked housing).
  • Reseat connectors: Carefully disconnect and reconnect all major harnesses to ensure good contact.
  • Firmware recovery: If Segway provides a recovery or reflash procedure (via app or USB), attempt to reinstall the firmware.

If E18 remains after these steps, the main control board will generally need replacement and re‑pairing with the mower’s components.

Advertisements

Repair Difficulty

Professional Required 5/5

Required Part

Main Control Board
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements