Robot vacuum shows E10 and refuses to start; app may indicate a sensor fault.

Safety first: Turn off the robot before removing or inserting the dust bin.

• Remove and reseat bin: Pull out the dust bin completely, check for debris on the bin rails, then slide it back in firmly until it clicks.
• Inspect sensor tab: Look for a small plastic tab or magnet on the bin that engages the sensor. Ensure it is not broken or missing.
• Clean sensor area: Use a dry cloth or compressed air to clean around the bin sensor slot or switch inside the robot.
• Test without debris: With the bin empty and properly seated, power on the robot and attempt to start a cleaning cycle.
• If E10 remains: The bin presence switch or Hall sensor may be defective. Replacement of the dust bin sensor switch assembly is required.