E13
Honiture
Airflow Sensor / Pressure Switch Error
Robot vacuum reports a fan or airflow error shortly after starting; dust bin and filters appear clean.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Airflow sensor tube blocked, Pressure sensor clogged with dust, Airflow sensor wiring loose, Airflow sensor failure
How to Fix / Troubleshooting
Safety first: Turn OFF the robot and remove the dust bin.
- Inspect air channels: Look for small tubes or channels leading from the suction path to a sensor. Remove any visible dust clumps or debris.
- Clean filters thoroughly: Even if they look clean, tap and, if allowed, wash the filters as per Honiture's instructions. Ensure they are completely dry before reinstalling.
- Check sensor connection: Open the top cover and locate the small airflow or pressure sensor board near the fan housing. Confirm the connector is secure.
- Test again: Reassemble and run a cleaning cycle. If the error returns quickly, the Airflow / Pressure Sensor may need replacement.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Airflow / Pressure Sensor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements