Robot vacuum reports a fan overcurrent or overheating error after running for a short time.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Filters heavily clogged, Air ducts partially blocked, Fan bearings worn causing drag, Fan motor windings damaged

Safety first: Turn OFF the robot and remove the dust bin.

Clean or replace filters: Thoroughly clean the primary and HEPA filters. If they are older than recommended by Honiture, replace them.
Inspect ducts: Check the suction path from the floor inlet to the fan housing for partial blockages.
Allow cooling: Let the robot rest for at least 30 minutes before restarting to clear any thermal protection.
Test again: If E17 returns quickly with clean filters, the Vacuum Fan Motor is likely overheating internally and should be replaced.

Hard 4/5

Vacuum Fan Motor Assembly

Check Price on Amazon

We may earn a commission from links on this page.