E24
AEG
Drain Pump Feedback / Control Error
Washer-dryer shows E24 and may not drain or may run the pump continuously.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Incorrect pump wiring, Faulty pump feedback circuit on PCB, Moisture or corrosion on control board, Damaged harness connector at pump
How to Fix / Troubleshooting
Safety: Disconnect power before accessing internal components.
- Verify correct wiring: Compare the pump wiring to the AEG wiring diagram (usually behind the rear panel or in the user manual). Ensure connectors are on the correct terminals and fully seated.
- Inspect connectors: Check the pump and PCB connectors for corrosion, bent pins, or loose fit. Clean and reseat.
- Dry moisture: If there has been a leak, allow the control area to dry completely for 24 hours after fixing the leak, then retest.
- Board diagnosis: If wiring and pump are correct and E24 remains, the control board's pump feedback circuit is likely faulty and the PCB should be replaced by a professional.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Main Control Board (AEG PCB)
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements