E32
AEG
Pressure Sensor Calibration / Level Error
Washer-dryer intermittently stops with E32, often during filling or before spin.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Incorrect pressure sensor calibration, Blocked pressure hose, Faulty pressure sensor, Software error in control board
How to Fix / Troubleshooting
Safety: Unplug the appliance before service.
- Clean and inspect pressure system: As with E31, ensure the pressure hose and air trap are clean and unobstructed, and the hose is airtight.
- Reset appliance: After cleaning, leave the machine unplugged for 10–15 minutes to allow the control to reset, then run a rinse/spin cycle.
- Replace sensor if needed: If E32 recurs, replace the AEG pressure sensor with a compatible part.
- Software update: In some models, an AEG technician can update the firmware to correct level detection issues.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
AEG Pressure Sensor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements