AEG Drying Overheating

Washer-dryer door glass becomes extremely hot during drying, laundry feels overheated.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Blocked air flow through condenser, Failed dry temperature sensor, Stuck dry heater relay, Lint build-up on heater

Safety: Stop the cycle, unplug the appliance, and allow it to cool fully before inspection.

Clean airflow path: Thoroughly clean the condenser, lint filters, and air ducts to restore proper airflow.
Check dry NTC sensor: Locate the drying temperature sensor (often in the air duct) and test its resistance. Replace if readings are incorrect.
Inspect heater relay: If the heater remains on continuously, the relay on the PCB may be stuck and the board should be replaced by a technician.

Hard 4/5

AEG Dryer NTC Sensor

Check Price on Amazon

We may earn a commission from links on this page.