AEG
Overheating Component or Belt Slippage
Washer-dryer emits a burning smell or smoke during operation.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Drive belt slipping on pulley, Foreign object trapped between drum and tub, Motor overheating, Electrical short in wiring or PCB
How to Fix / Troubleshooting
Safety: Immediately switch off and unplug the appliance. Do not continue to use until the cause is found.
- Inspect rear area: Remove the rear panel and check the belt for glazing or burning. Replace if damaged and ensure correct tension.
- Check for obstructions: Look through the drum holes for trapped items like bra wires that may be rubbing.
- Smell components: Carefully identify if the smell comes from the motor, belt, or electronics. Burnt electronics require PCB replacement by a professional.
Advertisements
Repair Difficulty
Hard
4/5
Advertisements