Washer-dryer displays E10 and will not start or stops shortly after starting; often related to water intake or configuration.

Safety first: Switch off and unplug before checking wiring.

• Confirm installation: Ensure the cold water hose is connected to a live tap and the tap is fully open. Bush washer-dryers typically require only a cold feed.
• Check hose and filters: Inspect the inlet hose for kinks and clean the mesh filter at the machine end.
• Inspect wiring to inlet valve: Remove the top cover and verify that the inlet valve connector is firmly attached and not damaged.
• Power reset: Unplug the machine for 10 minutes to allow the control to reset, then reconnect and try a short cycle.
• Further action: If E10 persists despite good water supply and wiring, the control board may be misconfigured or faulty. This typically requires a Bush service technician to reprogram or replace the PCB.