Bush
Bush Washer-Dryer Combos Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
E01
Washer-dryer will not start a cycle and may display E01 shortly after pressing Start; door remains unlocked.
Door Lock Circuit Failure
E02
Washer-dryer does not fill with water or fills very slowly, then stops and shows E02.
Water Inlet Timeout / Fill Fault
E03
Washer-dryer will not drain water; drum remains full and E03 is displayed.
Drain Pump Timeout / Drainage Fault
E04
Washer-dryer overfills, may show E04, and sometimes leaks from the door or drawer.
Overfill / Pressure System Fault
E05
Washer-dryer stops during wash or rinse with E05; water may be cold when it should be hot.
Heating Circuit Fault
E06
Washer-dryer drum does not turn during wash or spin; E06 is displayed.
Motor Drive Fault
E07
Washer-dryer fails to reach or maintain spin speed; E07 appears during spin.
Tachometer / Speed Sensor Fault
E08
Washer-dryer shows E08 and may stop mid-cycle; sometimes associated with overheating or unusual smells.
Main Control Board / Power Module Fault
E09
Washer-dryer stops during drying cycle with E09; clothes remain wet and cold.
Dryer Heating Circuit Fault
E10
Washer-dryer displays E10 and will not start or stops shortly after starting; often related to water intake or configuration.
Configuration / Water Supply Error
E11
Washer-dryer shows E11 and may stop with water still in the drum or fail to progress between stages.
Pressure Switch Signal Error
E12
Washer-dryer displays E12 during drying; drum may turn but there is little or no heat and poor drying performance.
Dryer Airflow / Condenser Fault
E13
Washer-dryer shows E13 and may stop with water in the base tray; sometimes accompanied by beeping and no operation.
Anti-Flood / Leak Detection Activated
E21
Washer-dryer fails to spin or drain properly and displays E21.
Drain Pump or Motor Lock Fault
E30
Washer-dryer door will not lock or unlock correctly and E30 is displayed.
Door Lock / Unlock Error
E40
Washer-dryer displays E40 and refuses to start; often accompanied by a door symbol on the display.
Door Not Closed / Door Switch Error
E41
Washer-dryer intermittently shows E41; sometimes starts after several attempts.
Intermittent Door Lock Signal Fault
E50
Washer-dryer shows E50 and may stop during spin or wash; drum may jerk or not move.
General Motor Error
E60
Washer-dryer shows E60 during drying; drying performance is poor or non-existent.
General Drying System Error
E90
Washer-dryer displays E90 and will not operate; often after a power surge or interruption.
Communication / Configuration Error
Symptom
Washer-dryer displays incorrect time remaining or behaves unpredictably with cycle times.
Control Logic / Sensor Feedback Anomaly
Symptom
Washer-dryer does not dry clothes properly; clothes come out damp even after a full drying cycle.
Poor Drying Performance
Symptom
Washer-dryer door will not open at the end of the cycle; no error code shown.
Door Stuck / Lock Not Releasing
Symptom
Washer-dryer drum does not spin at high speed; clothes come out very wet but machine completes the cycle.
No or Poor Final Spin
Symptom
Washer-dryer emits a burning smell or hot plastic smell during operation.
Overheating Component / Friction
Symptom
Washer-dryer fills with water but drum does not turn during wash; no error code displayed.
Drum Drive Failure (No Agitation)
Symptom
Washer-dryer is extremely noisy during spin, with rumbling or grinding sounds.
Drum Bearing Wear / Failure
Symptom
Washer-dryer leaks water from the front, usually around the door area.
Door Seal / Front Leak
Symptom
Washer-dryer leaks water from the rear or underneath the machine.
Internal Hose / Pump Leak
Symptom
Washer-dryer leaves clothes soaking wet after the cycle, even though it appears to have spun.
Ineffective Spin / Residual Water
Symptom
Washer-dryer leaves detergent marks or white streaks on clothes after washing.
Detergent Dispensing / Rinsing Issue
Symptom
Washer-dryer makes a scraping or metallic rubbing noise when the drum turns.
Foreign Object Between Drum and Tub
Symptom
Washer-dryer makes loud banging or knocking noises during spin; machine may move across the floor.
Excessive Vibration / Suspension Fault
Symptom
Washer-dryer produces a strong mouldy or musty smell from the drum and during drying.
Biofilm / Mould Build-Up
Symptom
Washer-dryer stops mid-drying cycle and will not restart drying until cooled.
Dryer Overheat / Thermal Cut-Out Activation
Symptom
Washer-dryer takes much longer than expected to complete cycles; timer seems to pause or count up.
Extended Cycle Time / Control Logic Compensation
Symptom
Washer-dryer trips the household circuit breaker or RCD when starting or during a cycle.
Electrical Short / Earth Leakage
Symptom
Washer-dryer will not power on at all; no lights or display, completely dead.
No Power / Supply Fault
Symptom
Washer-dryer will not start a cycle; lights are on but pressing Start does nothing.
User Interface / Start Circuit Fault
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| E01 |
Washer-dryer will not start a cycle and may display E01 shortly after pressing Start; door remains unlocked.
|
Door Lock Circuit Failure | View Details |
| E02 |
Washer-dryer does not fill with water or fills very slowly, then stops and shows E02.
|
Water Inlet Timeout / Fill Fault | View Details |
| E03 |
Washer-dryer will not drain water; drum remains full and E03 is displayed.
|
Drain Pump Timeout / Drainage Fault | View Details |
| E04 |
Washer-dryer overfills, may show E04, and sometimes leaks from the door or drawer.
|
Overfill / Pressure System Fault | View Details |
| E05 |
Washer-dryer stops during wash or rinse with E05; water may be cold when it should be hot.
|
Heating Circuit Fault | View Details |
| E06 |
Washer-dryer drum does not turn during wash or spin; E06 is displayed.
|
Motor Drive Fault | View Details |
| E07 |
Washer-dryer fails to reach or maintain spin speed; E07 appears during spin.
|
Tachometer / Speed Sensor Fault | View Details |
| E08 |
Washer-dryer shows E08 and may stop mid-cycle; sometimes associated with overheating or unusual smells.
|
Main Control Board / Power Module Fault | View Details |
| E09 |
Washer-dryer stops during drying cycle with E09; clothes remain wet and cold.
|
Dryer Heating Circuit Fault | View Details |
| E10 |
Washer-dryer displays E10 and will not start or stops shortly after starting; often related to water intake or configuration.
|
Configuration / Water Supply Error | View Details |
| E11 |
Washer-dryer shows E11 and may stop with water still in the drum or fail to progress between stages.
|
Pressure Switch Signal Error | View Details |
| E12 |
Washer-dryer displays E12 during drying; drum may turn but there is little or no heat and poor drying performance.
|
Dryer Airflow / Condenser Fault | View Details |
| E13 |
Washer-dryer shows E13 and may stop with water in the base tray; sometimes accompanied by beeping and no operation.
|
Anti-Flood / Leak Detection Activated | View Details |
| E21 |
Washer-dryer fails to spin or drain properly and displays E21.
|
Drain Pump or Motor Lock Fault | View Details |
| E30 |
Washer-dryer door will not lock or unlock correctly and E30 is displayed.
|
Door Lock / Unlock Error | View Details |
| E40 |
Washer-dryer displays E40 and refuses to start; often accompanied by a door symbol on the display.
|
Door Not Closed / Door Switch Error | View Details |
| E41 |
Washer-dryer intermittently shows E41; sometimes starts after several attempts.
|
Intermittent Door Lock Signal Fault | View Details |
| E50 |
Washer-dryer shows E50 and may stop during spin or wash; drum may jerk or not move.
|
General Motor Error | View Details |
| E60 |
Washer-dryer shows E60 during drying; drying performance is poor or non-existent.
|
General Drying System Error | View Details |
| E90 |
Washer-dryer displays E90 and will not operate; often after a power surge or interruption.
|
Communication / Configuration Error | View Details |
| – |
Washer-dryer displays incorrect time remaining or behaves unpredictably with cycle times.
|
Control Logic / Sensor Feedback Anomaly | View Details |
| – |
Washer-dryer does not dry clothes properly; clothes come out damp even after a full drying cycle.
|
Poor Drying Performance | View Details |
| – |
Washer-dryer door will not open at the end of the cycle; no error code shown.
|
Door Stuck / Lock Not Releasing | View Details |
| – |
Washer-dryer drum does not spin at high speed; clothes come out very wet but machine completes the cycle.
|
No or Poor Final Spin | View Details |
| – |
Washer-dryer emits a burning smell or hot plastic smell during operation.
|
Overheating Component / Friction | View Details |
| – |
Washer-dryer fills with water but drum does not turn during wash; no error code displayed.
|
Drum Drive Failure (No Agitation) | View Details |
| – |
Washer-dryer is extremely noisy during spin, with rumbling or grinding sounds.
|
Drum Bearing Wear / Failure | View Details |
| – |
Washer-dryer leaks water from the front, usually around the door area.
|
Door Seal / Front Leak | View Details |
| – |
Washer-dryer leaks water from the rear or underneath the machine.
|
Internal Hose / Pump Leak | View Details |
| – |
Washer-dryer leaves clothes soaking wet after the cycle, even though it appears to have spun.
|
Ineffective Spin / Residual Water | View Details |
| – |
Washer-dryer leaves detergent marks or white streaks on clothes after washing.
|
Detergent Dispensing / Rinsing Issue | View Details |
| – |
Washer-dryer makes a scraping or metallic rubbing noise when the drum turns.
|
Foreign Object Between Drum and Tub | View Details |
| – |
Washer-dryer makes loud banging or knocking noises during spin; machine may move across the floor.
|
Excessive Vibration / Suspension Fault | View Details |
| – |
Washer-dryer produces a strong mouldy or musty smell from the drum and during drying.
|
Biofilm / Mould Build-Up | View Details |
| – |
Washer-dryer stops mid-drying cycle and will not restart drying until cooled.
|
Dryer Overheat / Thermal Cut-Out Activation | View Details |
| – |
Washer-dryer takes much longer than expected to complete cycles; timer seems to pause or count up.
|
Extended Cycle Time / Control Logic Compensation | View Details |
| – |
Washer-dryer trips the household circuit breaker or RCD when starting or during a cycle.
|
Electrical Short / Earth Leakage | View Details |
| – |
Washer-dryer will not power on at all; no lights or display, completely dead.
|
No Power / Supply Fault | View Details |
| – |
Washer-dryer will not start a cycle; lights are on but pressing Start does nothing.
|
User Interface / Start Circuit Fault | View Details |
No matching codes found
Advertisements