E19
Caple
EEPROM / Configuration Error
Washer-dryer displays E19 and may not respond to program selection or start commands.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted firmware on main PCB, Incorrect configuration data, Failed memory chip on control board, Power surge during operation
How to Fix / Troubleshooting
Safety first: Disconnect the appliance from mains before accessing electronics.
- Step 1 – Power reset: Unplug the washer-dryer for 15–20 minutes, then reconnect and attempt to select a basic program.
- Step 2 – Check model settings: If recently replaced, ensure the main PCB is the correct part number for your Caple washer-dryer model.
- Step 3 – Service mode (technician only): Some E19 faults require reprogramming or configuration via service tools. This must be done by an authorized Caple service engineer.
- Step 4 – PCB replacement: If reprogramming is not possible or fails, the main PCB will need replacement.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Main Control Board (PCB)
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements