5U
GE Profile UltraFast
Software / Program Execution Error
Display shows 5U and the unit may not complete cycles reliably.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted cycle program in main control board, Electrical interference during operation, Failing main control board memory
How to Fix / Troubleshooting
Safety first: Unplug the appliance before accessing internal controls.
Steps to attempt resolution:
- Factory reset: Perform a factory reset of the control (see user manual for specific button sequence).
- Power cycle: Disconnect power for 10 minutes to clear volatile memory, then reconnect and run a basic cycle.
- Environmental check: Ensure the unit is not sharing a circuit with heavy inductive loads (e.g., large motors) that may cause interference.
- Control replacement: If 5U persists, replace the main control board with the correct GE Profile UltraFast part number.
Software-related issues are typically resolved only by control board replacement or firmware update by an authorized technician.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements