Washer-dryer combo shows E10 shortly after starting; no water enters the drum.

Safety first: Unplug the unit and close water valves before disconnecting hoses.

• Verify water supply: Confirm both hot and cold valves are open and that water flows at nearby faucets.
• Inspect hoses: Ensure hoses are connected to the correct hot/cold taps and not kinked.
• Clean inlet screens: Remove hoses and clean screens in the water inlet valve.
• Test fill: Restore water and power, then start a cycle. If still no fill, the water inlet valve or water level sensor may be faulty and require replacement.