E13
GE Profile
Leak Detected / Overflow Protection
Washer-dryer combo shows E13 and may leak internally; water detected in base pan (if equipped with float switch).
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Leaking hose or clamp, Torn door gasket, Cracked tub or pump housing, Loose detergent dispenser hose
How to Fix / Troubleshooting
Safety first: Unplug the unit and turn off water supply immediately to prevent further leakage.
- Inspect visible leaks: Look around the door, front, and rear for obvious water trails.
- Check base pan: Remove the lower front or rear panel to inspect the base. If water is present, dry it completely with towels or a wet/dry vacuum.
- Run a short fill test: With panels off, run a quick fill and watch for drips from hoses, pump, tub, or dispenser.
- Repair leak source: Tighten or replace leaking hose clamps, replace a torn door gasket, or replace a cracked drain pump housing or tub as needed.
- Reset leak sensor: Once dry and repaired, plug the unit back in and run a test cycle to confirm no further leaks.
Advertisements
Repair Difficulty
Hard
4/5
Advertisements