E24
GE Profile
Drain Pump Electrical Fault
Washer-dryer combo shows E24 and may stop with water still in the tub; sometimes accompanied by unusual pump noise.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Open or shorted drain pump motor, Loose pump wiring connector, Failed control triac/relay for pump
How to Fix / Troubleshooting
Safety first: Unplug the unit before testing the pump electrically.
- Inspect wiring: Access the drain pump and check the wiring connector for looseness or corrosion. Reseat firmly.
- Test pump resistance: Disconnect the pump and measure coil resistance with a multimeter. Compare to specifications; open or very low resistance indicates a bad pump.
- Replace pump: If the pump tests faulty, install a new drain pump assembly.
- Control board check: If the pump is good but not receiving voltage during drain, the main control board's pump driver may be defective and require replacement.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Drain Pump Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements