Washer-dryer combo displays E82 and cycles may stop unexpectedly; some functions may not respond.

Safety first: Unplug the unit before accessing the control board compartment.

• Check power supply: Verify the outlet voltage is correct and stable. Avoid using long extension cords or power strips.
• Inspect control board: Remove the top or rear panel to access the main control. Look for burnt components, discoloration, or a burnt odor.
• Disconnect peripherals: If possible, disconnect non-essential loads (e.g., heater, motor) one at a time and test to see if E82 clears, which may indicate a shorted component.
• Reset control: Some models allow a diagnostic reset via button sequence (refer to service manual). Perform this reset and recheck operation.
• Replace main control: If visual inspection and resets do not resolve the error, replace the main control board. Transfer all connectors carefully, one at a time, to avoid miswiring.