Washer-dryer combo displays H20 and takes a long time to fill or does not fill at all.

Safety first: Unplug the unit and turn off water supply before disconnecting hoses.

• Check faucets: Ensure both hot and cold supply valves are fully open.
• Inspect hoses: Look for kinks or freezing (in unheated spaces). Thaw frozen hoses safely and insulate if needed.
• Clean inlet screens: Disconnect hoses at the rear and clean the small screens inside the water inlet valve ports.
• Test fill: Reconnect hoses, restore water and power, and run a fill test. If one temperature still does not fill, that side of the valve is likely bad.
• Replace water inlet valve: Install a new water inlet valve assembly if cleaning and hose checks do not restore normal fill.