Washer-dryer does not take in water for drying (condenser type) or shows E10 at start of drying.

Safety first: Unplug the appliance and close water taps before working on water circuits.

• Check for combined valve: Many Grundig washer-dryer combos use a multi-way inlet valve that feeds both wash and condenser circuits. Identify the condenser outlet from the valve using the service diagram.
• Inspect valve and hoses: Remove the top cover and check the small hose from the inlet valve to the condenser section for kinks or blockages. Clean any scale or debris.
• Test condenser valve coil: Use a multimeter to measure resistance of the condenser valve coil. An open circuit indicates a failed coil.
• Clean condenser spray: If accessible, clean the condenser spray nozzle or channel where water is introduced to cool the drying air. Blockages can cause E10.
• Replace valve if needed: Replace the multi-way inlet valve or condenser valve section with a Grundig-compatible assembly if the coil is defective.