Grundig Washer-Dryer Combos Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
E01
Washer-dryer will not start; door symbol flashes and cycle will not begin.
Door Lock Failure
E02
Washer-dryer does not fill with water or fills very slowly; cycle stops early with E02.
Water Inlet Fault
E03
Washer-dryer does not drain; water remains in drum and E03 is displayed.
Drain Pump or Drainage Fault
E04
Washer-dryer overfills or shows E04 shortly after starting; water may be visible in the door seal area.
Overfill / Pressure System Fault
E05
Washer-dryer stops during wash; water remains cold and E05 is displayed.
Water Heating Circuit Fault
E06
Washer-dryer stops mid-cycle; drum does not turn and E06 appears.
Motor Drive Fault
E07
Washer-dryer fails to reach or maintain spin speed; E07 is displayed.
Unbalanced Load / Spin Control Fault
E08
Washer-dryer displays E08 and will not start or stops shortly after starting.
Door Lock Circuit or Door Open Detection Fault
E09
Washer-dryer stops during drying cycle; no heat is produced and E09 is shown.
Dryer Heating Circuit Fault
E10
Washer-dryer does not take in water for drying (condenser type) or shows E10 at start of drying.
Dryer Condenser Water Supply Fault
E11
Washer-dryer shows E11 and stops; often associated with drying performance issues or overheating.
Dryer Airflow / Overheat Fault
E12
Washer-dryer displays E12 during drying; clothes remain damp and cycle ends prematurely.
Dryer Moisture Sensing Fault
E13
Washer-dryer shows E13 and may stop with water in the base tray; sometimes accompanied by pump running continuously.
Leakage / Anti-Flood System Activation
E14
Washer-dryer shows E14 and will not start; often related to control electronics.
Main Control Board Communication / Internal Error
E15
Washer-dryer displays E15; some functions may be disabled or machine may not respond to commands.
User Interface / Display Board Fault
E16
Washer-dryer shows E16 and may stop with the drum not turning or turning erratically.
Motor Tachometer / Speed Feedback Fault
E17
Washer-dryer shows E17 and may not fill correctly; often related to water level sensing.
Pressure Sensor / Water Level Signal Fault
E18
Washer-dryer shows E18; often associated with drain time-out or partial drainage.
Extended Drain Time / Partial Blockage
E19
Washer-dryer shows E19; may be related to detergent dispenser or water distribution.
Detergent Dispenser / Water Distribution Valve Fault
E20
Washer-dryer shows E20; machine may stop with water in drum or fail to progress.
General Drain / Pump System Error
E21
Washer-dryer shows E21; drum may not rotate or may rotate only briefly.
Motor Overload / Stalled Motor
E22
Washer-dryer shows E22; often associated with overheating or temperature sensor issues in wash cycle.
Wash NTC Temperature Sensor Fault
E23
Washer-dryer shows E23; may be related to drain pump triac or control issue.
Drain Pump Control Circuit Fault
E24
Washer-dryer shows E24; may not respond to certain commands or options.
Option Module / Auxiliary Board Communication Fault
E25
Washer-dryer shows E25; may be associated with drying sensor or humidity control.
Dryer NTC / Temperature Sensor Fault
E26
Washer-dryer shows E26; may be related to water hardness or dosing sensor (on models with automatic dosing).
Water Quality / Dosing Sensor Fault
E27
Washer-dryer shows E27; often associated with mains power issues.
Mains Voltage / Frequency Error
Symptom
Washer-dryer combo will not power on at all; no lights or display.
No Power / Dead Appliance
Symptom
Washer-dryer displays random lights or resets mid-cycle without showing a specific error code.
Intermittent Power / Control Board Fault
Symptom
Washer-dryer does not start cycle; display is on but Start/Pause button does nothing.
User Interface Input Fault
Symptom
Washer-dryer door will not unlock at end of cycle; clothes are trapped inside.
Door Lock Stuck Closed
Symptom
Washer-dryer drum does not turn during wash or spin, but machine fills and drains normally.
Drum Drive Failure
Symptom
Washer-dryer drying cycle runs but clothes come out damp or take very long to dry.
Poor Drying Performance
Symptom
Washer-dryer emits a burning smell or smoke during operation.
Overheating / Electrical Burning
Symptom
Washer-dryer emits a strong musty or moldy odor from the drum.
Biofilm / Mold Build-Up
Symptom
Washer-dryer leaks water from the front door area during wash.
Door Seal (Gasket) Leak
Symptom
Washer-dryer leaks water from underneath the machine.
Internal Hose or Component Leak
Symptom
Washer-dryer leaves clothes very wet at the end of cycle; spin seems weak or does not occur.
Poor Spin Performance
Symptom
Washer-dryer leaves detergent or softener residues on clothes after washing.
Poor Rinsing / Detergent Dispensing Issue
Symptom
Washer-dryer makes very loud rumbling or grinding noise during spin.
Drum Bearing Failure
Symptom
Washer-dryer produces a high-pitched squealing or screeching noise when spinning.
Drive Belt or Pulley Noise
Symptom
Washer-dryer produces loud banging or knocking during spin; machine may move across the floor.
Excessive Vibration / Suspension Fault
Symptom
Washer-dryer takes excessively long to complete cycles; time remaining jumps or extends.
Cycle Time Extension / Heating or Sensing Issue
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| E01 |
Washer-dryer will not start; door symbol flashes and cycle will not begin.
|
Door Lock Failure | View Details |
| E02 |
Washer-dryer does not fill with water or fills very slowly; cycle stops early with E02.
|
Water Inlet Fault | View Details |
| E03 |
Washer-dryer does not drain; water remains in drum and E03 is displayed.
|
Drain Pump or Drainage Fault | View Details |
| E04 |
Washer-dryer overfills or shows E04 shortly after starting; water may be visible in the door seal area.
|
Overfill / Pressure System Fault | View Details |
| E05 |
Washer-dryer stops during wash; water remains cold and E05 is displayed.
|
Water Heating Circuit Fault | View Details |
| E06 |
Washer-dryer stops mid-cycle; drum does not turn and E06 appears.
|
Motor Drive Fault | View Details |
| E07 |
Washer-dryer fails to reach or maintain spin speed; E07 is displayed.
|
Unbalanced Load / Spin Control Fault | View Details |
| E08 |
Washer-dryer displays E08 and will not start or stops shortly after starting.
|
Door Lock Circuit or Door Open Detection Fault | View Details |
| E09 |
Washer-dryer stops during drying cycle; no heat is produced and E09 is shown.
|
Dryer Heating Circuit Fault | View Details |
| E10 |
Washer-dryer does not take in water for drying (condenser type) or shows E10 at start of drying.
|
Dryer Condenser Water Supply Fault | View Details |
| E11 |
Washer-dryer shows E11 and stops; often associated with drying performance issues or overheating.
|
Dryer Airflow / Overheat Fault | View Details |
| E12 |
Washer-dryer displays E12 during drying; clothes remain damp and cycle ends prematurely.
|
Dryer Moisture Sensing Fault | View Details |
| E13 |
Washer-dryer shows E13 and may stop with water in the base tray; sometimes accompanied by pump running continuously.
|
Leakage / Anti-Flood System Activation | View Details |
| E14 |
Washer-dryer shows E14 and will not start; often related to control electronics.
|
Main Control Board Communication / Internal Error | View Details |
| E15 |
Washer-dryer displays E15; some functions may be disabled or machine may not respond to commands.
|
User Interface / Display Board Fault | View Details |
| E16 |
Washer-dryer shows E16 and may stop with the drum not turning or turning erratically.
|
Motor Tachometer / Speed Feedback Fault | View Details |
| E17 |
Washer-dryer shows E17 and may not fill correctly; often related to water level sensing.
|
Pressure Sensor / Water Level Signal Fault | View Details |
| E18 |
Washer-dryer shows E18; often associated with drain time-out or partial drainage.
|
Extended Drain Time / Partial Blockage | View Details |
| E19 |
Washer-dryer shows E19; may be related to detergent dispenser or water distribution.
|
Detergent Dispenser / Water Distribution Valve Fault | View Details |
| E20 |
Washer-dryer shows E20; machine may stop with water in drum or fail to progress.
|
General Drain / Pump System Error | View Details |
| E21 |
Washer-dryer shows E21; drum may not rotate or may rotate only briefly.
|
Motor Overload / Stalled Motor | View Details |
| E22 |
Washer-dryer shows E22; often associated with overheating or temperature sensor issues in wash cycle.
|
Wash NTC Temperature Sensor Fault | View Details |
| E23 |
Washer-dryer shows E23; may be related to drain pump triac or control issue.
|
Drain Pump Control Circuit Fault | View Details |
| E24 |
Washer-dryer shows E24; may not respond to certain commands or options.
|
Option Module / Auxiliary Board Communication Fault | View Details |
| E25 |
Washer-dryer shows E25; may be associated with drying sensor or humidity control.
|
Dryer NTC / Temperature Sensor Fault | View Details |
| E26 |
Washer-dryer shows E26; may be related to water hardness or dosing sensor (on models with automatic dosing).
|
Water Quality / Dosing Sensor Fault | View Details |
| E27 |
Washer-dryer shows E27; often associated with mains power issues.
|
Mains Voltage / Frequency Error | View Details |
| – |
Washer-dryer combo will not power on at all; no lights or display.
|
No Power / Dead Appliance | View Details |
| – |
Washer-dryer displays random lights or resets mid-cycle without showing a specific error code.
|
Intermittent Power / Control Board Fault | View Details |
| – |
Washer-dryer does not start cycle; display is on but Start/Pause button does nothing.
|
User Interface Input Fault | View Details |
| – |
Washer-dryer door will not unlock at end of cycle; clothes are trapped inside.
|
Door Lock Stuck Closed | View Details |
| – |
Washer-dryer drum does not turn during wash or spin, but machine fills and drains normally.
|
Drum Drive Failure | View Details |
| – |
Washer-dryer drying cycle runs but clothes come out damp or take very long to dry.
|
Poor Drying Performance | View Details |
| – |
Washer-dryer emits a burning smell or smoke during operation.
|
Overheating / Electrical Burning | View Details |
| – |
Washer-dryer emits a strong musty or moldy odor from the drum.
|
Biofilm / Mold Build-Up | View Details |
| – |
Washer-dryer leaks water from the front door area during wash.
|
Door Seal (Gasket) Leak | View Details |
| – |
Washer-dryer leaks water from underneath the machine.
|
Internal Hose or Component Leak | View Details |
| – |
Washer-dryer leaves clothes very wet at the end of cycle; spin seems weak or does not occur.
|
Poor Spin Performance | View Details |
| – |
Washer-dryer leaves detergent or softener residues on clothes after washing.
|
Poor Rinsing / Detergent Dispensing Issue | View Details |
| – |
Washer-dryer makes very loud rumbling or grinding noise during spin.
|
Drum Bearing Failure | View Details |
| – |
Washer-dryer produces a high-pitched squealing or screeching noise when spinning.
|
Drive Belt or Pulley Noise | View Details |
| – |
Washer-dryer produces loud banging or knocking during spin; machine may move across the floor.
|
Excessive Vibration / Suspension Fault | View Details |
| – |
Washer-dryer takes excessively long to complete cycles; time remaining jumps or extends.
|
Cycle Time Extension / Heating or Sensing Issue | View Details |
No matching codes found
Advertisements