Ikea
Overheating Component or Belt Slippage
Washer-dryer emits a burning smell during wash or dry cycles
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Drive belt slipping on pulley, Lint build-up on dryer heater, Failing motor with overheating windings, Electrical short at connectors
How to Fix / Troubleshooting
Safety first: Immediately stop the cycle, unplug the appliance, and do not use it until the source is identified. Risk of fire.
Step-by-step checks:
- 1. Visual inspection: Remove the rear and top panels. Look for burnt wiring, discolored connectors, or melted plastic near the motor, heater, and control board.
- 2. Check belt: Inspect the drive belt for glazing or burnt rubber smell. Replace if slipping or damaged.
- 3. Clean dryer heater area: Remove lint from around the dryer heating element and ducts.
- 4. Motor check: If the smell comes from the motor area and the motor is very hot, it may be failing and should be replaced.
- 5. Professional service: Any signs of burnt wiring or components warrant inspection and repair by a qualified technician.
Advertisements
Repair Difficulty
Hard
4/5
Advertisements