E19
Insignia
EEPROM / Configuration Data Error
Washer-dryer combo shows E19 and will not start; internal self-check fails at power-up.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted firmware on main control board, Incorrect replacement control board, Power surge damage to memory
How to Fix / Troubleshooting
Safety first: Disconnect power before handling the control board.
- Power reset: Unplug the unit for at least 10 minutes, then reconnect and see if the error clears.
- Check model configuration: If the main board was recently replaced, verify that the correct Insignia part number was installed for your exact washer-dryer combo model.
- Service mode reset: Some models allow a configuration reset via a service mode key sequence (refer to service documentation). Perform the reset if available.
- Replace control board: If E19 persists, the main control board's memory is likely corrupted and the board must be replaced. Use only the correct OEM board.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements