Insignia Washer-Dryer Combos Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
E1
Washer-dryer combo will not fill with water; cycle starts then quickly pauses and displays E1.
Water Inlet Timeout / No Fill
E10
Washer-dryer combo displays E10 and will not heat during drying; cycle runs but clothes remain wet and cool.
Dryer Temperature Sensor (NTC) Fault
E11
Washer-dryer combo shows E11 and stops; drum may be full of water and not progressing.
Overflow / Overfill Protection Error
E12
Washer-dryer combo displays E12 and will not start; control panel may light but no functions respond.
User Interface / Control Panel Communication Error
E13
Washer-dryer combo shows E13 and stops; drum may not rotate correctly or may jerk.
Motor Tachometer / Speed Sensor Error
E14
Washer-dryer combo displays E14 and stops; drying performance is poor and cycle may end prematurely.
Dryer Exhaust / Airflow Restriction Error
E15
Washer-dryer combo shows E15 and will not start; door appears closed but machine thinks it is open.
Door Open Detection Error
E16
Washer-dryer combo displays E16 and stops; motor may hum but drum does not move.
Motor Overload / Stall Error
E17
Washer-dryer combo shows E17 and stops; water temperature seems incorrect (too hot or too cold).
Wash Temperature Sensor (NTC) Error
E18
Washer-dryer combo displays E18 and stops; water remains in drum and door may stay locked.
Drain Time Exceeded / Partial Blockage
E19
Washer-dryer combo shows E19 and will not start; internal self-check fails at power-up.
EEPROM / Configuration Data Error
E2
Washer-dryer combo does not drain; water remains in drum and E2 is displayed.
Drain Pump Failure / Drain Timeout
E20
Washer-dryer combo displays E20 and stops; drying cycle may not start or may shut down quickly.
Dryer Motor / Blower Fault
E3
Washer-dryer combo drum does not spin or tumble; E3 appears during wash or spin.
Motor Drive Fault / Motor Unable to Start
E4
Washer-dryer combo displays E4 and stops during spin; drum may be banging or not reaching full speed.
Unbalanced Load / Out-of-Balance Detection
E5
Washer-dryer combo shows E5 and will not start drying; heater does not energize.
Dryer Heating Circuit Fault
E6
Washer-dryer combo displays E6 and stops; door remains locked or will not lock at start.
Door Lock / Door Switch Fault
E7
Washer-dryer combo shows E7 and stops mid-cycle; water level appears incorrect (either overfilled or underfilled).
Water Level Sensor / Pressure Switch Error
E8
Washer-dryer combo displays E8 and will not start or stops unexpectedly; control panel may be unresponsive.
Main Control Board Communication / Internal Fault
E9
Washer-dryer combo shows E9 and stops; water may be seen leaking into the base or out of the door.
Leak Detected / Overflow Protection
Symptom
Washer-dryer combo displays incorrect remaining time or jumps time frequently during cycles.
Cycle Time Estimation / Sensor Feedback Issue
Symptom
Washer-dryer combo displays lights but the selector knob or buttons do not respond correctly.
User Interface / Encoder Failure
Symptom
Washer-dryer combo does not dry clothes effectively; clothes come out damp after a full dry cycle.
Poor Drying Performance
Symptom
Washer-dryer combo door will not unlock at the end of the cycle; clothes are trapped inside.
Door Lock Stuck / Drain Not Complete
Symptom
Washer-dryer combo drum does not spin at all, but the unit fills and drains normally.
Drive Belt Failure
Symptom
Washer-dryer combo emits a burning smell during drying cycles.
Overheating / Lint Ignition Risk
Symptom
Washer-dryer combo fills with water even when turned off, slowly over time.
Inlet Valve Seepage
Symptom
Washer-dryer combo has a persistent musty or moldy odor inside the drum.
Biofilm / Mold Growth in Drum and Gasket
Symptom
Washer-dryer combo intermittently shuts off mid-cycle and then restarts or remains off.
Intermittent Power / Overheating Control
Symptom
Washer-dryer combo leaks water from the bottom or rear of the cabinet during operation.
Internal Hose or Pump Leak
Symptom
Washer-dryer combo leaks water from the front door area during wash or rinse cycles.
Door Gasket (Boot Seal) Leak
Symptom
Washer-dryer combo leaves clothes soaking wet at the end of the cycle.
No or Poor Final Spin
Symptom
Washer-dryer combo leaves detergent or fabric softener residue on clothes.
Detergent Dispensing / Rinse Inefficiency
Symptom
Washer-dryer combo makes a rattling or clanking noise during wash or spin.
Foreign Objects in Drum or Pump
Symptom
Washer-dryer combo makes loud banging or knocking noises during spin cycles.
Suspension / Shock Absorber Wear
Symptom
Washer-dryer combo powers on but will not start a cycle; pressing start does nothing.
Start Circuit / Control Lock Issue
Symptom
Washer-dryer combo produces a high-pitched squeal or grinding noise when spinning or tumbling.
Drum Bearing or Drive Pulley Wear
Symptom
Washer-dryer combo takes an unusually long time to complete cycles.
Extended Cycle Time / Sensor Misread
Symptom
Washer-dryer combo vibrates excessively and walks across the floor during spin.
Out-of-Balance Vibration / Installation Issue
Symptom
Washer-dryer combo will not start at all; no lights or display when pressing power.
No Power / Power Supply Issue
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| E1 |
Washer-dryer combo will not fill with water; cycle starts then quickly pauses and displays E1.
|
Water Inlet Timeout / No Fill | View Details |
| E10 |
Washer-dryer combo displays E10 and will not heat during drying; cycle runs but clothes remain wet and cool.
|
Dryer Temperature Sensor (NTC) Fault | View Details |
| E11 |
Washer-dryer combo shows E11 and stops; drum may be full of water and not progressing.
|
Overflow / Overfill Protection Error | View Details |
| E12 |
Washer-dryer combo displays E12 and will not start; control panel may light but no functions respond.
|
User Interface / Control Panel Communication Error | View Details |
| E13 |
Washer-dryer combo shows E13 and stops; drum may not rotate correctly or may jerk.
|
Motor Tachometer / Speed Sensor Error | View Details |
| E14 |
Washer-dryer combo displays E14 and stops; drying performance is poor and cycle may end prematurely.
|
Dryer Exhaust / Airflow Restriction Error | View Details |
| E15 |
Washer-dryer combo shows E15 and will not start; door appears closed but machine thinks it is open.
|
Door Open Detection Error | View Details |
| E16 |
Washer-dryer combo displays E16 and stops; motor may hum but drum does not move.
|
Motor Overload / Stall Error | View Details |
| E17 |
Washer-dryer combo shows E17 and stops; water temperature seems incorrect (too hot or too cold).
|
Wash Temperature Sensor (NTC) Error | View Details |
| E18 |
Washer-dryer combo displays E18 and stops; water remains in drum and door may stay locked.
|
Drain Time Exceeded / Partial Blockage | View Details |
| E19 |
Washer-dryer combo shows E19 and will not start; internal self-check fails at power-up.
|
EEPROM / Configuration Data Error | View Details |
| E2 |
Washer-dryer combo does not drain; water remains in drum and E2 is displayed.
|
Drain Pump Failure / Drain Timeout | View Details |
| E20 |
Washer-dryer combo displays E20 and stops; drying cycle may not start or may shut down quickly.
|
Dryer Motor / Blower Fault | View Details |
| E3 |
Washer-dryer combo drum does not spin or tumble; E3 appears during wash or spin.
|
Motor Drive Fault / Motor Unable to Start | View Details |
| E4 |
Washer-dryer combo displays E4 and stops during spin; drum may be banging or not reaching full speed.
|
Unbalanced Load / Out-of-Balance Detection | View Details |
| E5 |
Washer-dryer combo shows E5 and will not start drying; heater does not energize.
|
Dryer Heating Circuit Fault | View Details |
| E6 |
Washer-dryer combo displays E6 and stops; door remains locked or will not lock at start.
|
Door Lock / Door Switch Fault | View Details |
| E7 |
Washer-dryer combo shows E7 and stops mid-cycle; water level appears incorrect (either overfilled or underfilled).
|
Water Level Sensor / Pressure Switch Error | View Details |
| E8 |
Washer-dryer combo displays E8 and will not start or stops unexpectedly; control panel may be unresponsive.
|
Main Control Board Communication / Internal Fault | View Details |
| E9 |
Washer-dryer combo shows E9 and stops; water may be seen leaking into the base or out of the door.
|
Leak Detected / Overflow Protection | View Details |
| – |
Washer-dryer combo displays incorrect remaining time or jumps time frequently during cycles.
|
Cycle Time Estimation / Sensor Feedback Issue | View Details |
| – |
Washer-dryer combo displays lights but the selector knob or buttons do not respond correctly.
|
User Interface / Encoder Failure | View Details |
| – |
Washer-dryer combo does not dry clothes effectively; clothes come out damp after a full dry cycle.
|
Poor Drying Performance | View Details |
| – |
Washer-dryer combo door will not unlock at the end of the cycle; clothes are trapped inside.
|
Door Lock Stuck / Drain Not Complete | View Details |
| – |
Washer-dryer combo drum does not spin at all, but the unit fills and drains normally.
|
Drive Belt Failure | View Details |
| – |
Washer-dryer combo emits a burning smell during drying cycles.
|
Overheating / Lint Ignition Risk | View Details |
| – |
Washer-dryer combo fills with water even when turned off, slowly over time.
|
Inlet Valve Seepage | View Details |
| – |
Washer-dryer combo has a persistent musty or moldy odor inside the drum.
|
Biofilm / Mold Growth in Drum and Gasket | View Details |
| – |
Washer-dryer combo intermittently shuts off mid-cycle and then restarts or remains off.
|
Intermittent Power / Overheating Control | View Details |
| – |
Washer-dryer combo leaks water from the bottom or rear of the cabinet during operation.
|
Internal Hose or Pump Leak | View Details |
| – |
Washer-dryer combo leaks water from the front door area during wash or rinse cycles.
|
Door Gasket (Boot Seal) Leak | View Details |
| – |
Washer-dryer combo leaves clothes soaking wet at the end of the cycle.
|
No or Poor Final Spin | View Details |
| – |
Washer-dryer combo leaves detergent or fabric softener residue on clothes.
|
Detergent Dispensing / Rinse Inefficiency | View Details |
| – |
Washer-dryer combo makes a rattling or clanking noise during wash or spin.
|
Foreign Objects in Drum or Pump | View Details |
| – |
Washer-dryer combo makes loud banging or knocking noises during spin cycles.
|
Suspension / Shock Absorber Wear | View Details |
| – |
Washer-dryer combo powers on but will not start a cycle; pressing start does nothing.
|
Start Circuit / Control Lock Issue | View Details |
| – |
Washer-dryer combo produces a high-pitched squeal or grinding noise when spinning or tumbling.
|
Drum Bearing or Drive Pulley Wear | View Details |
| – |
Washer-dryer combo takes an unusually long time to complete cycles.
|
Extended Cycle Time / Sensor Misread | View Details |
| – |
Washer-dryer combo vibrates excessively and walks across the floor during spin.
|
Out-of-Balance Vibration / Installation Issue | View Details |
| – |
Washer-dryer combo will not start at all; no lights or display when pressing power.
|
No Power / Power Supply Issue | View Details |
No matching codes found
Advertisements