F14
JennAir
EEPROM or Program Memory Error
Display shows F14 and the unit may freeze or not accept input.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted control board firmware, failed EEPROM chip, power surge damage, defective main control board
How to Fix / Troubleshooting
Safety first: Unplug the washer-dryer combo before any disassembly.
- Power cycle: Disconnect power for at least 5 minutes, then restore and attempt to start a cycle. This can clear transient memory faults.
- Check environment: Ensure the unit is not exposed to excessive moisture or heat that could affect electronics.
- Inspect control board: Access the main control board and look for obvious damage such as burnt components or corrosion.
- Replace control board: If F14 reappears consistently, replace the main control board with the correct JennAir part, transferring all connectors carefully.
When to call a technician: Firmware-related issues and board replacement are best handled by a qualified technician.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Main Control Board (CCU)
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements