JennAir Washer-Dryer Combos Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
F01
Washer-dryer combo will not start any cycle; display shows F01 shortly after pressing Start.
Main Control Board Failure
F02
Washer-dryer combo stops mid-cycle and will not drain; display shows F02 or "F2".
Long Drain Fault
F03
Cycle stops early or will not start; display shows F03 and sometimes water remains in drum.
Water Level Pressure Sensor Fault
F05
Washer-dryer combo fills but does not advance; display shows F05 and may stop with water in drum.
Water Temperature Sensor (NTC) Fault
F06
Washer-dryer combo will not spin or tumble; display shows F06.
Motor Tachometer or Drive Motor Fault
F07
Washer-dryer combo will not heat during wash or dry; display shows F07.
Heating Circuit Fault
F08
Washer-dryer combo overfills or shows F08 shortly after filling starts.
Water Level Overfill Fault
F09
Display shows F09 and the unit may stop with water in the drum or not start at all.
Overflow or Water Leak Detected
F10
Washer-dryer combo will not fill; display shows F10 or "FILL" error.
Water Fill Fault
F11
Cycle stops and display shows F11; unit may not respond to commands.
Communication Error Between Control Boards
F13
Door will not lock or unlock properly; display shows F13.
Door Lock Circuit Fault
F14
Display shows F14 and the unit may freeze or not accept input.
EEPROM or Program Memory Error
F15
Dryer function will not heat; display shows F15 during drying cycles.
Dryer Heater Circuit Fault
F20
Display shows F20 and the unit may not fill or may abort the cycle early.
No Water Detected / Fill Timeout
F21
Washer-dryer combo stops with water in drum and shows F21; door may remain locked.
Long Drain / Pump Timeout
F22
Door will not lock at the start of a cycle; display shows F22.
Door Lock Failure to Lock
F23
Door will not unlock at end of cycle; display shows F23.
Door Lock Failure to Unlock
F24
Display shows F24 and cycle may stop during wash or rinse.
Water Temperature Sensor Out of Range
F25
Display shows F25; washer may not spin properly or may stop unexpectedly.
Drum Position / Motor Tachometer Error
F26
Display shows F26; unit may not respond correctly to door open/close.
Door Switch Input Error
F27
Display shows F27; washer may not spin or may behave erratically during spin.
Unbalanced Load / Out-of-Range Motor Speed
F28
Display shows F28; washer may not start or may stop mid-cycle.
Serial Communication Error (Motor/Control)
F29
Display shows F29; door may appear locked even when open, or unit refuses to start.
Door Lock Status Error
F30
Display shows F30; dryer function may not operate correctly.
Dryer Exhaust Thermistor Fault
F31
Display shows F31; dryer may overheat or shut down quickly.
Dryer Temperature Control Fault
F32
Display shows F32; washer may not detect load size correctly or may fill/spin oddly.
Load Sensing / Weight Sensor Fault
Symptom
Burning smell or smoke during drying cycles.
Lint Buildup and Overheating
Symptom
Clicking or rattling noise during wash or spin, especially with small items.
Foreign Object in Drum or Pump
Symptom
Clothes remain wet at the end of the wash cycle; spin seems weak.
Poor Spin Performance
Symptom
Detergent remains in the dispenser drawer at the end of the cycle.
Dispenser Water Flow Problem
Symptom
Dryer runs but clothes do not dry or take excessively long to dry.
Poor Drying Performance
Symptom
Dryer stops shortly after starting and clothes remain damp.
Moisture Sensor or Overheat Trip
Symptom
Excessive vibration and walking across the floor during spin cycles.
Out-of-Balance and Suspension Wear
Symptom
High-pitched squealing or screeching noise during tumble or spin.
Drive Belt or Idler Pulley Wear
Symptom
Loud grinding or rumbling noise during spin, getting worse over time.
Tub Bearing and Seal Failure
Symptom
Musty or moldy odor coming from the washer drum or door area.
Biofilm and Mold Buildup
Symptom
Washer fills and drains repeatedly without progressing through the cycle.
Water Level Sensing / Control Logic Issue
Symptom
Washer over-suds and may leak soap bubbles from the door or dispenser.
Oversudsing / Detergent Misuse
Symptom
Washer-dryer combo is leaking water from the front during wash cycles.
Door Boot (Gasket) Leak
Symptom
Washer-dryer combo powers on but will not start any cycle when Start is pressed.
Start Circuit / User Interface Fault
Symptom
Washer-dryer combo will not power on; no lights or display.
No Power / Dead Unit
Symptom
Water leaking from the rear or bottom of the washer-dryer combo during wash or drain.
Internal Hose or Pump Leak
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| F01 |
Washer-dryer combo will not start any cycle; display shows F01 shortly after pressing Start.
|
Main Control Board Failure | View Details |
| F02 |
Washer-dryer combo stops mid-cycle and will not drain; display shows F02 or "F2".
|
Long Drain Fault | View Details |
| F03 |
Cycle stops early or will not start; display shows F03 and sometimes water remains in drum.
|
Water Level Pressure Sensor Fault | View Details |
| F05 |
Washer-dryer combo fills but does not advance; display shows F05 and may stop with water in drum.
|
Water Temperature Sensor (NTC) Fault | View Details |
| F06 |
Washer-dryer combo will not spin or tumble; display shows F06.
|
Motor Tachometer or Drive Motor Fault | View Details |
| F07 |
Washer-dryer combo will not heat during wash or dry; display shows F07.
|
Heating Circuit Fault | View Details |
| F08 |
Washer-dryer combo overfills or shows F08 shortly after filling starts.
|
Water Level Overfill Fault | View Details |
| F09 |
Display shows F09 and the unit may stop with water in the drum or not start at all.
|
Overflow or Water Leak Detected | View Details |
| F10 |
Washer-dryer combo will not fill; display shows F10 or "FILL" error.
|
Water Fill Fault | View Details |
| F11 |
Cycle stops and display shows F11; unit may not respond to commands.
|
Communication Error Between Control Boards | View Details |
| F13 |
Door will not lock or unlock properly; display shows F13.
|
Door Lock Circuit Fault | View Details |
| F14 |
Display shows F14 and the unit may freeze or not accept input.
|
EEPROM or Program Memory Error | View Details |
| F15 |
Dryer function will not heat; display shows F15 during drying cycles.
|
Dryer Heater Circuit Fault | View Details |
| F20 |
Display shows F20 and the unit may not fill or may abort the cycle early.
|
No Water Detected / Fill Timeout | View Details |
| F21 |
Washer-dryer combo stops with water in drum and shows F21; door may remain locked.
|
Long Drain / Pump Timeout | View Details |
| F22 |
Door will not lock at the start of a cycle; display shows F22.
|
Door Lock Failure to Lock | View Details |
| F23 |
Door will not unlock at end of cycle; display shows F23.
|
Door Lock Failure to Unlock | View Details |
| F24 |
Display shows F24 and cycle may stop during wash or rinse.
|
Water Temperature Sensor Out of Range | View Details |
| F25 |
Display shows F25; washer may not spin properly or may stop unexpectedly.
|
Drum Position / Motor Tachometer Error | View Details |
| F26 |
Display shows F26; unit may not respond correctly to door open/close.
|
Door Switch Input Error | View Details |
| F27 |
Display shows F27; washer may not spin or may behave erratically during spin.
|
Unbalanced Load / Out-of-Range Motor Speed | View Details |
| F28 |
Display shows F28; washer may not start or may stop mid-cycle.
|
Serial Communication Error (Motor/Control) | View Details |
| F29 |
Display shows F29; door may appear locked even when open, or unit refuses to start.
|
Door Lock Status Error | View Details |
| F30 |
Display shows F30; dryer function may not operate correctly.
|
Dryer Exhaust Thermistor Fault | View Details |
| F31 |
Display shows F31; dryer may overheat or shut down quickly.
|
Dryer Temperature Control Fault | View Details |
| F32 |
Display shows F32; washer may not detect load size correctly or may fill/spin oddly.
|
Load Sensing / Weight Sensor Fault | View Details |
| – |
Burning smell or smoke during drying cycles.
|
Lint Buildup and Overheating | View Details |
| – |
Clicking or rattling noise during wash or spin, especially with small items.
|
Foreign Object in Drum or Pump | View Details |
| – |
Clothes remain wet at the end of the wash cycle; spin seems weak.
|
Poor Spin Performance | View Details |
| – |
Detergent remains in the dispenser drawer at the end of the cycle.
|
Dispenser Water Flow Problem | View Details |
| – |
Dryer runs but clothes do not dry or take excessively long to dry.
|
Poor Drying Performance | View Details |
| – |
Dryer stops shortly after starting and clothes remain damp.
|
Moisture Sensor or Overheat Trip | View Details |
| – |
Excessive vibration and walking across the floor during spin cycles.
|
Out-of-Balance and Suspension Wear | View Details |
| – |
High-pitched squealing or screeching noise during tumble or spin.
|
Drive Belt or Idler Pulley Wear | View Details |
| – |
Loud grinding or rumbling noise during spin, getting worse over time.
|
Tub Bearing and Seal Failure | View Details |
| – |
Musty or moldy odor coming from the washer drum or door area.
|
Biofilm and Mold Buildup | View Details |
| – |
Washer fills and drains repeatedly without progressing through the cycle.
|
Water Level Sensing / Control Logic Issue | View Details |
| – |
Washer over-suds and may leak soap bubbles from the door or dispenser.
|
Oversudsing / Detergent Misuse | View Details |
| – |
Washer-dryer combo is leaking water from the front during wash cycles.
|
Door Boot (Gasket) Leak | View Details |
| – |
Washer-dryer combo powers on but will not start any cycle when Start is pressed.
|
Start Circuit / User Interface Fault | View Details |
| – |
Washer-dryer combo will not power on; no lights or display.
|
No Power / Dead Unit | View Details |
| – |
Water leaking from the rear or bottom of the washer-dryer combo during wash or drain.
|
Internal Hose or Pump Leak | View Details |
No matching codes found
Advertisements