Door will not unlock at end of cycle; display shows F23.
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Possible Causes
How to Fix / Troubleshooting
Safety first: Unplug the unit. Do not force the door open with excessive pressure.
- Wait and cool down: Allow 5–10 minutes for the lock to cool; some locks remain engaged briefly after high-temperature cycles.
- Manual release: On many JennAir combos, a manual release tab is accessible behind the lower front panel or through the door boot area. Pull the tab gently to release the lock.
- Inspect lock assembly: Once open, remove the door lock and check for mechanical binding or heat damage. Replace if worn or burnt.
- Check wiring: Ensure the lock harness is secure and undamaged.
When to call a technician: If the door remains locked and you cannot access the manual release, or if the control is not releasing the lock, contact a professional.
Repair Difficulty
Required Part
We may earn a commission from links on this page.