F25
JennAir
Drum Position / Motor Tachometer Error
Display shows F25; washer may not spin properly or may stop unexpectedly.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Loose motor tach wiring, defective tach sensor, failing drive motor, control board motor circuit fault
How to Fix / Troubleshooting
Safety first: Unplug the appliance before accessing the motor.
- Inspect motor harness: Remove rear panel and verify the motor connector is fully seated and wires are intact.
- Check for drum obstruction: Ensure nothing is jammed between drum and tub that could impede rotation.
- Test spin: With the unit reassembled, run a spin-only cycle with no load. If F25 recurs, the tach sensor or motor may be defective.
- Replace motor assembly: If wiring is good and error persists, replace the drive motor with a JennAir-compatible unit.
When to call a technician: Motor and control diagnostics often require specialized tools; consider professional service.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Drive Motor Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements