Display shows F32; washer may not detect load size correctly or may fill/spin oddly.

Safety first: Disconnect power before accessing internal components.

• Check for mechanical binding: Spin the drum by hand to ensure it moves freely and does not rub the cabinet.
• Inspect load sensor: Some JennAir combos use a weight sensor under the tub or cabinet. Verify its wiring is intact and connectors are secure.
• Run calibration (if available): Consult the service manual for a load-sensing calibration cycle and run it with an empty drum.
• Replace sensor: If F32 persists and wiring is good, replace the load sensor with the correct part.

When to call a technician: If calibration and sensor replacement do not resolve the fault, professional diagnosis of the control system is recommended.