Washer-dryer combo is leaking water from the front during wash cycles.

Safety first: Unplug the unit and turn off water supplies before inspection.

• Inspect gasket: Open the door and carefully examine the rubber door boot all the way around. Look for tears, holes, or areas where the gasket has pulled away from the tub or front panel.
• Clean sealing surfaces: Wipe the gasket and door glass with a damp cloth to remove detergent residue, lint, and foreign objects that can break the seal.
• Check clamps: Gently pull back the gasket edge and verify that the inner and outer retaining clamps or springs are in place and tight. Re-seat or tighten as needed.
• Replace gasket if damaged: If you find rips or permanent deformation, remove the front panel (if required), release both clamps, and install a new JennAir-compatible door boot gasket. Ensure the drain holes at the bottom of the boot are correctly positioned.

When to call a technician: If you are not comfortable removing the front panel or fitting the new gasket evenly, seek professional service.