Washer-dryer combo displays E19 and may not respond to control inputs.

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Corrupted firmware on main PCB, Power surge damage, Faulty EEPROM chip, Loose PCB connectors

How to Fix / Troubleshooting

Safety first: Unplug the appliance before inspecting internal electronics.

Step-by-step checks:

Power reset: Disconnect power for at least 10 minutes to allow capacitors to discharge, then reconnect and test.
Inspect PCB connections: Remove the top cover and check that all connectors to the main PCB are firmly seated.

If E19 persists, the main control board likely requires reprogramming or replacement. This is not a user-serviceable repair and should be handled by an authorized Stoves service technician.

Repair Difficulty

Professional Required 5/5

Required Part

Main Control Board (PCB)

Check Price on Amazon

We may earn a commission from links on this page.