E60
Casarte
Heating System General Error
Washer displays E60 and does not heat, or trips breaker when heating should start
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Shorted heating element, Ground fault in heater, Faulty heater relay on PCB, Damaged heater wiring
How to Fix / Troubleshooting
Safety first: Unplug the washer. If a breaker has tripped, reset only after inspecting for obvious shorts.
- 1. Inspect heater area: Remove the rear panel and check the heating element and wiring for visible damage or burns.
- 2. Test heater to ground (for technicians): With the washer unplugged and heater disconnected, measure resistance between each heater terminal and ground. Any low resistance indicates a ground fault; replace the heater.
- 3. Check wiring: Repair any burnt or melted wires between the heater and main PCB.
- 4. PCB evaluation: If the heater and wiring are good, the main PCB heater relay or triac may be faulty and require replacement.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Tub Heating Element
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements