Washer shows F08, water level too high or overflow condition

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Stuck inlet valve, Faulty pressure switch, Siphoning due to low drain hose, Control board fault

Safety first: Unplug the washer and close water taps.

Check drain hose installation: Ensure correct height and no siphoning as described under E9.
Test inlet valve: If water continues to enter when unplugged, replace the inlet valve.
Inspect pressure system: Clean and check the pressure hose and sensor.

Hard 4/5

Water Inlet Valve Assembly

Check Price on Amazon

We may earn a commission from links on this page.