Hisense Water Level Sensing / Siphoning Issue

Washer fills and drains repeatedly without progressing into wash

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Drain hose installed too low causing siphoning, Faulty pressure sensor, Air leak in pressure hose, Control misinterpretation of level

Safety first: Unplug the washer before adjusting hoses.

Correct drain hose height: Ensure the drain hose is at the manufacturer-specified height and not sealed airtight into the standpipe.
Inspect pressure system: Check and clean the pressure hose and sensor as described under E6/E32.
Test cycle: After adjustments, run a short cycle and observe if the behavior stops.

Medium 3/5

Water Level Pressure Sensor

Check Price on Amazon

We may earn a commission from links on this page.