Washer shows E92; configuration or EEPROM error on control board.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Corrupted EEPROM data, Incorrect PCB replacement, Power surge damage, Firmware fault

Safety first: Disconnect power before handling the PCB.

1. Power reset: Unplug for 10 minutes and retry.
2. Check model configuration: If the PCB was recently replaced, ensure it is the correct Toshiba part and properly configured for the model (may require service mode).
3. Service mode reset: Some models allow resetting configuration via service mode; refer to Toshiba service documentation.
4. Replace PCB: If E92 persists, the control board memory is likely corrupted and must be replaced.

Professional Required 5/5

Main Control Board (PCB)

Check Price on Amazon

We may earn a commission from links on this page.