Warm air felt around the door edges; condensation forming on the outside of the glass door.

Safety: No internal electrical work is required, but unplugging is recommended if you will be adjusting hinges.

Steps:

• Inspect gasket: Close the door on a sheet of paper at several points around the perimeter. If the paper pulls out easily, the seal is weak in that area.
• Clean gasket: Wipe the door gasket and cabinet frame with warm soapy water to remove debris.
• Adjust door: Check that the door is square and level. Adjust hinge screws to correct sagging or misalignment.
• Replace gasket: If the gasket is cracked, hardened, or warped, remove it from the door channel and install a new Auseo-compatible gasket, pressing it fully into place.

Note: A good seal is critical for maintaining stable temperature and preventing excess compressor run time.