Beko
Control Output / Relay Failure
Display works but compressor and fan do not start (unit stays warm)
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed compressor relay on main PCB, Broken wiring to compressor, Faulty fan relay, Safety thermostat tripped
How to Fix / Troubleshooting
Safety: Unplug the appliance before accessing the rear compartment or control board.
- Check for error codes: If none are displayed, proceed with hardware checks.
- Inspect wiring: Verify that the harness from the main PCB to the compressor and fan is intact and firmly connected.
- Test compressor relay: With the board removed, visually inspect the relay for burn marks. Relay testing and live voltage checks should be done by a qualified technician.
- Replace main PCB: If the board is not sending power to the compressor/fan when it should, replace the main control board.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements