E14
Hotpoint
Temperature Calibration / EEPROM Fault
E14 displayed, compressor runs continuously or not at all, temperature does not match setpoint
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted control board memory, Power surge affecting EEPROM, Incorrect factory calibration data, Failing main control board
How to Fix / Troubleshooting
Safety: Disconnect mains power before servicing electronics.
- Power cycle: Unplug the unit for at least 10 minutes to allow the control to fully reset, then reconnect.
- Factory reset (if available): Consult the user manual for a key combination to restore factory settings. Perform the reset and monitor operation.
- Check for other issues: Ensure sensors and fans are working correctly, as these can influence calibration.
- If E14 returns: The main control board’s memory is likely corrupted. Replace the board with a genuine Hotpoint module.
- Post-replacement check: Verify that the displayed temperature matches an independent thermometer placed inside the cabinet.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements