Door does not seal properly; condensation or frost forms around the door frame.

Work with the unit unplugged if you need to adjust hinges or remove the door.

• Inspect gasket: Run your hand around the Luma door gasket to feel for gaps, tears, or hardened sections.
• Warm and reshape: Use a hair dryer on low to gently warm warped gasket areas, then pull them outward to improve contact. Do not overheat.
• Adjust hinges: Loosen hinge screws slightly and adjust the door so it sits square in the opening, then retighten.
• Replace gasket: If the gasket is cracked or cannot be reshaped, remove it from the door channel and install a new OEM Luma gasket of the correct size.

After adjustment or replacement, close the door on a sheet of paper at several points; you should feel consistent resistance when pulling the paper out.