Pevino
No Power to Control / Dead Appliance
Control panel is completely dead; no lights or display, but outlet has power.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Blown internal fuse on main control board, Failed main control board power supply, Loose mains input wiring, Damaged power cord
How to Fix / Troubleshooting
Safety: Unplug the unit before opening any panels. Capacitors can retain charge; avoid touching board components.
- Verify outlet: Test the wall outlet with another appliance to confirm power.
- Inspect power cord: Check for visible damage. Replace the power cord if cut or burned.
- Check mains connections: Remove the rear panel and inspect the terminal block and wiring to the main control board. Tighten loose screws and reseat connectors.
- Board fuse: Some Pevino boards have a replaceable fuse. If accessible and visibly blown, replace with the exact same rating. If it blows again, a deeper fault exists.
- Replace main control board: If no obvious wiring issue is found, install a new main control board matched to your model.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements