E10
Pevino
Door Switch / Door Sensor Fault
Display shows E10 and the door alarm may sound even when the door is closed.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed magnetic reed switch or Hall sensor, Misaligned door magnet, Broken door switch wiring in cabinet frame, Connector issue at control board
How to Fix / Troubleshooting
Safety: Disconnect power before removing trims or gaskets.
- Identify sensor type: Pevino wine coolers typically use a magnetic door switch embedded in the cabinet frame and a magnet in the door.
- Check door alignment: Ensure the door closes squarely and the gasket seals evenly. Adjust hinges if the door is sagging and not aligning with the frame sensor area.
- Test magnet: Place a small magnet over the frame area where the sensor is located and see if the alarm stops (with power on). If it does, the door magnet may be weak or misaligned.
- Inspect gasket and trim: Carefully pull back the gasket near the sensor area to access the switch wiring. Check for broken or pinched wires.
- Replace components: Install a new door switch sensor or door magnet as needed, ensuring correct orientation and alignment.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Door Switch Sensor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements