E17
Pevino
Zone Separation / Air Damper Control Fault
Display shows E17 and the dual-zone temperatures cannot be set independently.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Stuck or failed air damper motor between zones, Broken damper flap, Disconnected damper harness, Control board damper driver failure
How to Fix / Troubleshooting
Safety: Unplug the cooler before accessing internal ducts.
- Locate damper: In Pevino dual-zone models, an air damper assembly is typically located between the upper and lower compartments behind an interior panel.
- Access and inspect: Remove the relevant panel to expose the damper. Check if the flap moves freely by hand (with power off).
- Check for obstructions: Ensure no insulation, wiring, or foreign objects are blocking the damper.
- Inspect wiring: Verify the damper motor connector is secure and wires are intact.
- Replace damper assembly: If the motor is unresponsive or the flap is broken, install a new air damper motor assembly designed for your Pevino model.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Air Damper Motor Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements