Electrolux Coffee Makers Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
E01
Machine will not start a brew cycle; display shows E01 shortly after power-on.
Main Power Supply or Control Board Fault
E02
Display shows E02 and the machine stops during preheating; no brewing starts.
Thermal Sensor / NTC Probe Failure
E03
Machine displays E03 and stops; water does not heat or only lukewarm coffee is dispensed.
Heating Circuit / Thermoblock Failure
E04
Display shows E04 and brewing stops; sometimes accompanied by loud pump noise and no water at the spout.
Water Flow / Flowmeter Error
E05
Machine shows E05 and stops; often occurs during or after steam use, with no steam output.
Steam Thermostat / Overheat Protection Triggered
E06
Display shows E06; brew group does not move or makes a brief noise then stops.
Brew Group Drive Motor / Position Sensor Error
E07
Machine displays E07; water leaks internally or into the drip tray instead of the cup during brewing.
Overpressure or Internal Leak Detection Error
E08
Display shows E08; grinder does not run or stops shortly after starting, no ground coffee is delivered.
Grinder Motor / Burr Blockage Fault
E09
Machine shows E09; pump is very loud but little or no water reaches the brew group.
Water Pump / Priming Failure
E10
Display shows E10; machine reports a water circuit error and refuses to start brewing.
General Hydraulic Circuit Fault
E11
Machine displays E11; the milk frother or cappuccinatore does not function correctly.
Milk Frothing System Error
E12
Display shows E12; the machine cannot detect the water tank or reports 'No Water' even when full.
Water Tank Presence / Level Detection Fault
E13
Machine shows E13; internal temperature too high, machine shuts down or refuses to start.
Overtemperature / Ventilation Fault
E14
Display shows E14; communication error between user interface and main control board.
Communication Bus / UI Board Fault
E15
Machine displays E15; internal leak detected, machine may shut down for safety.
Internal Leak / Drip Tray Sensor Fault
E16
Display shows E16; door or service panel open error, machine will not brew.
Door / Service Panel Switch Fault
E17
Machine shows E17; used coffee grounds container not detected or reported as full even when empty.
Dreg Drawer / Grounds Container Sensor Fault
E18
Display shows E18; descaling cycle cannot start or completes immediately.
Descaling Program / Sensor Fault
Symptom
Brew group is stuck and cannot be removed or reinserted.
Brew Group Jam / Misalignment
Symptom
Buttons or touch keys on the control panel do not respond or respond intermittently.
Keypad / Touch Sensor Failure
Symptom
Coffee is very bitter, over-extracted, or has a burnt taste.
Over-Extraction / Excessive Brewing Temperature
Symptom
Coffee maker does not power on at all; no lights or display, but outlet has power.
No Power / Dead Appliance
Symptom
Coffee maker drips coffee very slowly or takes a long time to brew a cup.
Restricted Coffee Flow
Symptom
Coffee maker powers on but will not start brewing when the start button is pressed.
Start Command / Control Logic Failure
Symptom
Coffee tastes weak or watery even on normal or strong settings.
Under-Extraction / Low Coffee Strength
Symptom
Display is dim, flickering, or some segments are missing.
Display / Backlight Failure
Symptom
Grinder runs but makes a harsh grinding or metallic scraping noise.
Grinder Burr Misalignment or Foreign Object
Symptom
Machine brews but coffee is lukewarm or not hot enough.
Insufficient Brewing Temperature
Symptom
Machine does not grind beans; only hot water passes through or a 'no beans' message appears despite beans in hopper.
Bean Detection / Grinder Feed Problem
Symptom
Machine emits a burning smell during operation.
Overheating or Electrical Burning
Symptom
Machine frequently requests descaling even after a recent descaling cycle.
Descale Indicator / Sensor Miscalibration
Symptom
Machine is very noisy during operation, with loud vibration or rattling sounds.
Excessive Vibration / Mechanical Noise
Symptom
Machine shuts off unexpectedly during brewing or heating.
Intermittent Power Loss / Thermal Cutout
Symptom
Milk froth is poor quality: large bubbles or mostly hot milk with little foam.
Inadequate Milk Frothing Performance
Symptom
Milk frother does not draw milk or produces only steam.
Milk Suction Failure
Symptom
Steam wand drips continuously even when steam is turned off.
Leaking Steam Valve
Symptom
Unpleasant odor or moldy smell from the coffee maker, especially from the spout or drip tray.
Hygiene / Biofilm Build-Up
Symptom
Used coffee grounds are very wet and sludgy, or pucks fall apart.
Improper Coffee Puck Formation
Symptom
Water leaking from under the coffee maker onto the countertop.
External Water Leak
Symptom
Water or coffee leaking into the drip tray excessively, even when not brewing.
Internal Bypass Leak
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| E01 |
Machine will not start a brew cycle; display shows E01 shortly after power-on.
|
Main Power Supply or Control Board Fault | View Details |
| E02 |
Display shows E02 and the machine stops during preheating; no brewing starts.
|
Thermal Sensor / NTC Probe Failure | View Details |
| E03 |
Machine displays E03 and stops; water does not heat or only lukewarm coffee is dispensed.
|
Heating Circuit / Thermoblock Failure | View Details |
| E04 |
Display shows E04 and brewing stops; sometimes accompanied by loud pump noise and no water at the spout.
|
Water Flow / Flowmeter Error | View Details |
| E05 |
Machine shows E05 and stops; often occurs during or after steam use, with no steam output.
|
Steam Thermostat / Overheat Protection Triggered | View Details |
| E06 |
Display shows E06; brew group does not move or makes a brief noise then stops.
|
Brew Group Drive Motor / Position Sensor Error | View Details |
| E07 |
Machine displays E07; water leaks internally or into the drip tray instead of the cup during brewing.
|
Overpressure or Internal Leak Detection Error | View Details |
| E08 |
Display shows E08; grinder does not run or stops shortly after starting, no ground coffee is delivered.
|
Grinder Motor / Burr Blockage Fault | View Details |
| E09 |
Machine shows E09; pump is very loud but little or no water reaches the brew group.
|
Water Pump / Priming Failure | View Details |
| E10 |
Display shows E10; machine reports a water circuit error and refuses to start brewing.
|
General Hydraulic Circuit Fault | View Details |
| E11 |
Machine displays E11; the milk frother or cappuccinatore does not function correctly.
|
Milk Frothing System Error | View Details |
| E12 |
Display shows E12; the machine cannot detect the water tank or reports 'No Water' even when full.
|
Water Tank Presence / Level Detection Fault | View Details |
| E13 |
Machine shows E13; internal temperature too high, machine shuts down or refuses to start.
|
Overtemperature / Ventilation Fault | View Details |
| E14 |
Display shows E14; communication error between user interface and main control board.
|
Communication Bus / UI Board Fault | View Details |
| E15 |
Machine displays E15; internal leak detected, machine may shut down for safety.
|
Internal Leak / Drip Tray Sensor Fault | View Details |
| E16 |
Display shows E16; door or service panel open error, machine will not brew.
|
Door / Service Panel Switch Fault | View Details |
| E17 |
Machine shows E17; used coffee grounds container not detected or reported as full even when empty.
|
Dreg Drawer / Grounds Container Sensor Fault | View Details |
| E18 |
Display shows E18; descaling cycle cannot start or completes immediately.
|
Descaling Program / Sensor Fault | View Details |
| – |
Brew group is stuck and cannot be removed or reinserted.
|
Brew Group Jam / Misalignment | View Details |
| – |
Buttons or touch keys on the control panel do not respond or respond intermittently.
|
Keypad / Touch Sensor Failure | View Details |
| – |
Coffee is very bitter, over-extracted, or has a burnt taste.
|
Over-Extraction / Excessive Brewing Temperature | View Details |
| – |
Coffee maker does not power on at all; no lights or display, but outlet has power.
|
No Power / Dead Appliance | View Details |
| – |
Coffee maker drips coffee very slowly or takes a long time to brew a cup.
|
Restricted Coffee Flow | View Details |
| – |
Coffee maker powers on but will not start brewing when the start button is pressed.
|
Start Command / Control Logic Failure | View Details |
| – |
Coffee tastes weak or watery even on normal or strong settings.
|
Under-Extraction / Low Coffee Strength | View Details |
| – |
Display is dim, flickering, or some segments are missing.
|
Display / Backlight Failure | View Details |
| – |
Grinder runs but makes a harsh grinding or metallic scraping noise.
|
Grinder Burr Misalignment or Foreign Object | View Details |
| – |
Machine brews but coffee is lukewarm or not hot enough.
|
Insufficient Brewing Temperature | View Details |
| – |
Machine does not grind beans; only hot water passes through or a 'no beans' message appears despite beans in hopper.
|
Bean Detection / Grinder Feed Problem | View Details |
| – |
Machine emits a burning smell during operation.
|
Overheating or Electrical Burning | View Details |
| – |
Machine frequently requests descaling even after a recent descaling cycle.
|
Descale Indicator / Sensor Miscalibration | View Details |
| – |
Machine is very noisy during operation, with loud vibration or rattling sounds.
|
Excessive Vibration / Mechanical Noise | View Details |
| – |
Machine shuts off unexpectedly during brewing or heating.
|
Intermittent Power Loss / Thermal Cutout | View Details |
| – |
Milk froth is poor quality: large bubbles or mostly hot milk with little foam.
|
Inadequate Milk Frothing Performance | View Details |
| – |
Milk frother does not draw milk or produces only steam.
|
Milk Suction Failure | View Details |
| – |
Steam wand drips continuously even when steam is turned off.
|
Leaking Steam Valve | View Details |
| – |
Unpleasant odor or moldy smell from the coffee maker, especially from the spout or drip tray.
|
Hygiene / Biofilm Build-Up | View Details |
| – |
Used coffee grounds are very wet and sludgy, or pucks fall apart.
|
Improper Coffee Puck Formation | View Details |
| – |
Water leaking from under the coffee maker onto the countertop.
|
External Water Leak | View Details |
| – |
Water or coffee leaking into the drip tray excessively, even when not brewing.
|
Internal Bypass Leak | View Details |
No matching codes found
Advertisements