Teka Microwaves Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
dE
Microwave display shows dE (door error) and will not start; door appears closed.
Door Open Detection Fault
E01
Microwave does not start; display shows E01 immediately after pressing START.
Door Interlock Safety Circuit Fault
E02
Microwave stops heating shortly after start; display shows E02 and beeps.
Magnetron Overheat Protection Triggered
E03
Microwave runs (light and fan on) but does not heat; display shows E03 after a few seconds.
Magnetron / High Voltage Circuit Failure
E04
Microwave display shows E04 and unit will not start; sometimes accompanied by a loud humming noise before error appears.
High Voltage Overcurrent / Short Circuit Protection
E05
Microwave display shows E05 and the turntable and fan do not start when pressing START.
Inverter Power Module Fault (for inverter-type Teka microwaves)
E06
Microwave shows E06 and beeps; cooking cannot be started. Sometimes appears after a power surge.
Control Panel / Keypad Communication Error
E07
Microwave display shows E07 and interior light and fan do not come on when starting a program.
Low Voltage Power Supply Fault
E08
Microwave shows E08 and stops mid-cycle; sometimes accompanied by a hot smell from the top or side.
Cavity Overheat / Temperature Sensor Error
E09
Microwave combination or grill mode shows E09 and will not start, while pure microwave mode may still work.
Grill Heating Element Circuit Fault
E10
Microwave shows E10 when using convection or hot air mode; fan may not run.
Convection Heater / Fan Circuit Fault
E11
Microwave shows E11 and stops; interior lamp may flicker when opening/closing the door.
Door Latch / Door Sensor Alignment Error
E12
Microwave shows E12 and beeps continuously until unplugged; no cooking functions work.
Stuck Key / Keypad Short Circuit
E13
Microwave shows E13 when starting; interior light comes on but turntable and fan do not run.
Motor Drive Circuit Fault
E14
Microwave shows E14 and stops; often associated with steam cooking or high humidity use.
Humidity / Steam Sensor Error
E15
Microwave shows E15 and will not start; clock and basic display still work.
Configuration / EEPROM Data Error
Err
Display shows Err or flashes Err when attempting to set time or program; some buttons may not respond.
General Input / Programming Error
H0
Display shows H0 or HO and microwave does not heat, though timer counts down.
Child Lock / Demo Mode Active (model-dependent code)
PF
Display shows PF (power failure) after a power cut; clock is reset and previous program is lost.
Power Interruption Indication
SE
Display shows SE (Sensor Error) and microwave will not start cooking.
Temperature / Sensor System Fault
Symptom
Microwave buttons are unresponsive or require very hard pressing; some keys work intermittently.
Keypad Wear / Control Panel Failure
Symptom
Microwave cavity accumulates condensation or water droplets on walls and door after cooking.
Condensation / Steam Management Issue
Symptom
Microwave clock loses time or resets randomly without a full power outage.
Control Board Power Stability Issue
Symptom
Microwave convection (hot air) mode does not heat, but fan runs and microwave mode works.
Convection Heating Element Failure
Symptom
Microwave display and buttons work, but pressing START does nothing; no relay click or internal activity.
Start Circuit / Relay Drive Failure
Symptom
Microwave display is dim, flickering, or some segments are missing, but cooking still works.
Display / VFD or LED Module Degradation
Symptom
Microwave does not power on at all; display is blank and no lights or sounds occur.
No Power / Dead Appliance
Symptom
Microwave door glass is loose, rattles, or shows signs of separation from the door frame.
Door Glass / Frame Bond Failure
Symptom
Microwave door is difficult to open or does not latch smoothly; sometimes causes intermittent operation.
Mechanical Door / Latch Wear
Symptom
Microwave emits a crackling or popping sound and visible sparks inside the cavity during cooking.
Cavity Arcing / Waveguide Contamination
Symptom
Microwave exterior becomes excessively hot to the touch during normal use, especially on top or sides.
Insufficient Ventilation / Cooling Fault
Symptom
Microwave grill function works, but microwave heating does not (food browns on top but remains cold inside).
Microwave Generation Failure with Grill OK
Symptom
Microwave interior light does not come on, but cooking and other functions work normally.
Cavity Lamp Failure
Symptom
Microwave interior light, fan, and turntable run with the door open, or continue running after door is opened.
Door Interlock Switches Stuck or Miswired
Symptom
Microwave makes loud buzzing or humming noise during operation, louder than usual, sometimes with reduced heating.
High Voltage Transformer or Magnetron Noise
Symptom
Microwave makes rattling or scraping noises from the turntable area during operation.
Turntable Support / Mechanical Noise
Symptom
Microwave produces a burning smell or smoke from vents during or after cooking.
Overheating / Component or Food Residue Burning
Symptom
Microwave runs (light, fan, and turntable operate) but food remains cold or only slightly warm.
No Heating / Reduced Microwave Power
Symptom
Microwave stops mid-cycle and resets, sometimes losing the clock; may happen when using high power or grill.
Power Drop / Overcurrent Reset
Symptom
Microwave trips the household circuit breaker or RCD as soon as START is pressed.
Short Circuit / Earth Leakage Under Load
Symptom
Turntable does not rotate during cooking, but heating still works.
Turntable Drive Failure
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| dE |
Microwave display shows dE (door error) and will not start; door appears closed.
|
Door Open Detection Fault | View Details |
| E01 |
Microwave does not start; display shows E01 immediately after pressing START.
|
Door Interlock Safety Circuit Fault | View Details |
| E02 |
Microwave stops heating shortly after start; display shows E02 and beeps.
|
Magnetron Overheat Protection Triggered | View Details |
| E03 |
Microwave runs (light and fan on) but does not heat; display shows E03 after a few seconds.
|
Magnetron / High Voltage Circuit Failure | View Details |
| E04 |
Microwave display shows E04 and unit will not start; sometimes accompanied by a loud humming noise before error appears.
|
High Voltage Overcurrent / Short Circuit Protection | View Details |
| E05 |
Microwave display shows E05 and the turntable and fan do not start when pressing START.
|
Inverter Power Module Fault (for inverter-type Teka microwaves) | View Details |
| E06 |
Microwave shows E06 and beeps; cooking cannot be started. Sometimes appears after a power surge.
|
Control Panel / Keypad Communication Error | View Details |
| E07 |
Microwave display shows E07 and interior light and fan do not come on when starting a program.
|
Low Voltage Power Supply Fault | View Details |
| E08 |
Microwave shows E08 and stops mid-cycle; sometimes accompanied by a hot smell from the top or side.
|
Cavity Overheat / Temperature Sensor Error | View Details |
| E09 |
Microwave combination or grill mode shows E09 and will not start, while pure microwave mode may still work.
|
Grill Heating Element Circuit Fault | View Details |
| E10 |
Microwave shows E10 when using convection or hot air mode; fan may not run.
|
Convection Heater / Fan Circuit Fault | View Details |
| E11 |
Microwave shows E11 and stops; interior lamp may flicker when opening/closing the door.
|
Door Latch / Door Sensor Alignment Error | View Details |
| E12 |
Microwave shows E12 and beeps continuously until unplugged; no cooking functions work.
|
Stuck Key / Keypad Short Circuit | View Details |
| E13 |
Microwave shows E13 when starting; interior light comes on but turntable and fan do not run.
|
Motor Drive Circuit Fault | View Details |
| E14 |
Microwave shows E14 and stops; often associated with steam cooking or high humidity use.
|
Humidity / Steam Sensor Error | View Details |
| E15 |
Microwave shows E15 and will not start; clock and basic display still work.
|
Configuration / EEPROM Data Error | View Details |
| Err |
Display shows Err or flashes Err when attempting to set time or program; some buttons may not respond.
|
General Input / Programming Error | View Details |
| H0 |
Display shows H0 or HO and microwave does not heat, though timer counts down.
|
Child Lock / Demo Mode Active (model-dependent code) | View Details |
| PF |
Display shows PF (power failure) after a power cut; clock is reset and previous program is lost.
|
Power Interruption Indication | View Details |
| SE |
Display shows SE (Sensor Error) and microwave will not start cooking.
|
Temperature / Sensor System Fault | View Details |
| – |
Microwave buttons are unresponsive or require very hard pressing; some keys work intermittently.
|
Keypad Wear / Control Panel Failure | View Details |
| – |
Microwave cavity accumulates condensation or water droplets on walls and door after cooking.
|
Condensation / Steam Management Issue | View Details |
| – |
Microwave clock loses time or resets randomly without a full power outage.
|
Control Board Power Stability Issue | View Details |
| – |
Microwave convection (hot air) mode does not heat, but fan runs and microwave mode works.
|
Convection Heating Element Failure | View Details |
| – |
Microwave display and buttons work, but pressing START does nothing; no relay click or internal activity.
|
Start Circuit / Relay Drive Failure | View Details |
| – |
Microwave display is dim, flickering, or some segments are missing, but cooking still works.
|
Display / VFD or LED Module Degradation | View Details |
| – |
Microwave does not power on at all; display is blank and no lights or sounds occur.
|
No Power / Dead Appliance | View Details |
| – |
Microwave door glass is loose, rattles, or shows signs of separation from the door frame.
|
Door Glass / Frame Bond Failure | View Details |
| – |
Microwave door is difficult to open or does not latch smoothly; sometimes causes intermittent operation.
|
Mechanical Door / Latch Wear | View Details |
| – |
Microwave emits a crackling or popping sound and visible sparks inside the cavity during cooking.
|
Cavity Arcing / Waveguide Contamination | View Details |
| – |
Microwave exterior becomes excessively hot to the touch during normal use, especially on top or sides.
|
Insufficient Ventilation / Cooling Fault | View Details |
| – |
Microwave grill function works, but microwave heating does not (food browns on top but remains cold inside).
|
Microwave Generation Failure with Grill OK | View Details |
| – |
Microwave interior light does not come on, but cooking and other functions work normally.
|
Cavity Lamp Failure | View Details |
| – |
Microwave interior light, fan, and turntable run with the door open, or continue running after door is opened.
|
Door Interlock Switches Stuck or Miswired | View Details |
| – |
Microwave makes loud buzzing or humming noise during operation, louder than usual, sometimes with reduced heating.
|
High Voltage Transformer or Magnetron Noise | View Details |
| – |
Microwave makes rattling or scraping noises from the turntable area during operation.
|
Turntable Support / Mechanical Noise | View Details |
| – |
Microwave produces a burning smell or smoke from vents during or after cooking.
|
Overheating / Component or Food Residue Burning | View Details |
| – |
Microwave runs (light, fan, and turntable operate) but food remains cold or only slightly warm.
|
No Heating / Reduced Microwave Power | View Details |
| – |
Microwave stops mid-cycle and resets, sometimes losing the clock; may happen when using high power or grill.
|
Power Drop / Overcurrent Reset | View Details |
| – |
Microwave trips the household circuit breaker or RCD as soon as START is pressed.
|
Short Circuit / Earth Leakage Under Load | View Details |
| – |
Turntable does not rotate during cooking, but heating still works.
|
Turntable Drive Failure | View Details |
No matching codes found
Advertisements