ETA
ETA Multicookers Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
E1
Multicooker will not start a program and displays E1 shortly after pressing START.
Lid Not Detected / Lid Switch Circuit Fault
E10
E10 appears when trying to start a program; the cooker may beep continuously.
Open Lid Detected During Cooking Start
E11
E11 error appears intermittently during long cooking cycles, sometimes accompanied by incomplete cooking.
Intermittent Power Supply / Voltage Error
E12
E12 appears and the cooker does not heat; fan (if present) may still run.
Secondary Temperature Sensor Fault (Lid or Ambient)
E13
E13 error appears during pressure cooking; cooker may stop and release steam.
Pressure Release Timeout / Slow Depressurization
E14
E14 is displayed and the cooker refuses to start any program.
Internal Memory / Firmware Error
E15
E15 appears when selecting high-temperature frying or sauté programs.
High-Temperature Mode Protection / Sensor Mismatch
E16
E16 error appears and the cooker may shut down unexpectedly during cooking.
Fan or Internal Cooling Failure (on fan-equipped models)
E17
E17 appears immediately after plugging in; no buttons respond.
Keypad / Touch Panel Communication Error
E18
E18 appears during keep-warm or low-temperature programs.
Low-Temperature Sensor Drift / Calibration Error
E2
Multicooker beeps and shows E2, program will not start or stops immediately.
Inner Pot Not Detected / Pot Presence Sensor Fault
E3
During heating or pressure cooking, the display shows E3 and the cooker stops heating.
Overtemperature Protection / Bottom Sensor Overheat
E4
E4 appears shortly after starting a pressure program; cooker may not build pressure.
Overpressure / Pressure Sensor Fault
E5
E5 error appears and the cooker stops heating or will not start a program.
NTC Sensor Open / Short Circuit
E6
E6 is displayed and the cooker does not heat or stops mid-cycle.
Heating Element Circuit Fault
E7
E7 appears when trying to start a pressure program; cooker may heat but never reaches pressure.
Lid Seal / Pressure Build Failure Detected
E8
E8 error appears, often accompanied by rapid beeping, and the cooker stops heating.
Excessive Pressure / Safety Protection Triggered
E9
E9 is displayed and the cooker does not respond to program selection or heating.
Internal Communication / Control Board Fault
Symptom
Burnt smell and food stuck to the bottom of the pot; cooker may show overheat errors or stop early.
Food Scorching / Localized Overheating
Symptom
Buttons or touch keys respond intermittently or require very hard presses.
Unresponsive Control Panel
Symptom
Condensation or water drips down the sides of the cooker during or after cooking.
Condensation Management / Collector Overflow
Symptom
Display segments are missing or unreadable; some numbers or icons do not show.
Partial Display Failure
Symptom
Display works but cooker does not heat; food remains cold even after program time.
No Heating / Open Heater Circuit
Symptom
Inner pot coating is peeling or scratched; food sticks easily.
Non-Stick Coating Degradation
Symptom
Keep-warm function overheats food, causing drying or burning at the bottom.
Keep-Warm Temperature Too High
Symptom
Lid is stuck and cannot be opened after cooking; float valve appears down and no steam is visible.
Mechanical Lid Jam
Symptom
Loud hissing from the steam release valve throughout cooking; food seems undercooked.
Steam Release Valve Not Sealing
Symptom
Multicooker does not power on at all; no lights or display.
No Power / Dead Appliance
Symptom
Multicooker heats but never reaches pressure; steam constantly escapes from lid.
Pressure Not Building
Symptom
Multicooker powers on but will not start any program; pressing START does nothing.
Start Circuit / Keypad Failure
Symptom
Multicooker trips the household circuit breaker or RCD when plugged in or when heating starts.
Short Circuit / Earth Leakage
Symptom
Multicooker vibrates excessively or moves on the countertop during operation.
Excessive Vibration
Symptom
Persistent electrical or burning plastic smell during use.
Overheating Components / Insulation Damage
Symptom
Programs do not start at the delayed time or delay timer behaves unpredictably.
Timer / Clock Function Fault
Symptom
Programs end too early or cooking time is shorter than set; food is undercooked.
Premature Program Termination
Symptom
Steam or water leaks from the side of the lid or around the hinge during pressure cooking.
Lid Deformation / Hinge Misalignment
Symptom
Unusual rattling, clicking, or buzzing noises from the base during operation.
Mechanical Vibration / Loose Components
Symptom
Water or foam spurts from the steam release valve during pressure cooking.
Foaming / Overfilled Pot
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| E1 |
Multicooker will not start a program and displays E1 shortly after pressing START.
|
Lid Not Detected / Lid Switch Circuit Fault | View Details |
| E10 |
E10 appears when trying to start a program; the cooker may beep continuously.
|
Open Lid Detected During Cooking Start | View Details |
| E11 |
E11 error appears intermittently during long cooking cycles, sometimes accompanied by incomplete cooking.
|
Intermittent Power Supply / Voltage Error | View Details |
| E12 |
E12 appears and the cooker does not heat; fan (if present) may still run.
|
Secondary Temperature Sensor Fault (Lid or Ambient) | View Details |
| E13 |
E13 error appears during pressure cooking; cooker may stop and release steam.
|
Pressure Release Timeout / Slow Depressurization | View Details |
| E14 |
E14 is displayed and the cooker refuses to start any program.
|
Internal Memory / Firmware Error | View Details |
| E15 |
E15 appears when selecting high-temperature frying or sauté programs.
|
High-Temperature Mode Protection / Sensor Mismatch | View Details |
| E16 |
E16 error appears and the cooker may shut down unexpectedly during cooking.
|
Fan or Internal Cooling Failure (on fan-equipped models) | View Details |
| E17 |
E17 appears immediately after plugging in; no buttons respond.
|
Keypad / Touch Panel Communication Error | View Details |
| E18 |
E18 appears during keep-warm or low-temperature programs.
|
Low-Temperature Sensor Drift / Calibration Error | View Details |
| E2 |
Multicooker beeps and shows E2, program will not start or stops immediately.
|
Inner Pot Not Detected / Pot Presence Sensor Fault | View Details |
| E3 |
During heating or pressure cooking, the display shows E3 and the cooker stops heating.
|
Overtemperature Protection / Bottom Sensor Overheat | View Details |
| E4 |
E4 appears shortly after starting a pressure program; cooker may not build pressure.
|
Overpressure / Pressure Sensor Fault | View Details |
| E5 |
E5 error appears and the cooker stops heating or will not start a program.
|
NTC Sensor Open / Short Circuit | View Details |
| E6 |
E6 is displayed and the cooker does not heat or stops mid-cycle.
|
Heating Element Circuit Fault | View Details |
| E7 |
E7 appears when trying to start a pressure program; cooker may heat but never reaches pressure.
|
Lid Seal / Pressure Build Failure Detected | View Details |
| E8 |
E8 error appears, often accompanied by rapid beeping, and the cooker stops heating.
|
Excessive Pressure / Safety Protection Triggered | View Details |
| E9 |
E9 is displayed and the cooker does not respond to program selection or heating.
|
Internal Communication / Control Board Fault | View Details |
| – |
Burnt smell and food stuck to the bottom of the pot; cooker may show overheat errors or stop early.
|
Food Scorching / Localized Overheating | View Details |
| – |
Buttons or touch keys respond intermittently or require very hard presses.
|
Unresponsive Control Panel | View Details |
| – |
Condensation or water drips down the sides of the cooker during or after cooking.
|
Condensation Management / Collector Overflow | View Details |
| – |
Display segments are missing or unreadable; some numbers or icons do not show.
|
Partial Display Failure | View Details |
| – |
Display works but cooker does not heat; food remains cold even after program time.
|
No Heating / Open Heater Circuit | View Details |
| – |
Inner pot coating is peeling or scratched; food sticks easily.
|
Non-Stick Coating Degradation | View Details |
| – |
Keep-warm function overheats food, causing drying or burning at the bottom.
|
Keep-Warm Temperature Too High | View Details |
| – |
Lid is stuck and cannot be opened after cooking; float valve appears down and no steam is visible.
|
Mechanical Lid Jam | View Details |
| – |
Loud hissing from the steam release valve throughout cooking; food seems undercooked.
|
Steam Release Valve Not Sealing | View Details |
| – |
Multicooker does not power on at all; no lights or display.
|
No Power / Dead Appliance | View Details |
| – |
Multicooker heats but never reaches pressure; steam constantly escapes from lid.
|
Pressure Not Building | View Details |
| – |
Multicooker powers on but will not start any program; pressing START does nothing.
|
Start Circuit / Keypad Failure | View Details |
| – |
Multicooker trips the household circuit breaker or RCD when plugged in or when heating starts.
|
Short Circuit / Earth Leakage | View Details |
| – |
Multicooker vibrates excessively or moves on the countertop during operation.
|
Excessive Vibration | View Details |
| – |
Persistent electrical or burning plastic smell during use.
|
Overheating Components / Insulation Damage | View Details |
| – |
Programs do not start at the delayed time or delay timer behaves unpredictably.
|
Timer / Clock Function Fault | View Details |
| – |
Programs end too early or cooking time is shorter than set; food is undercooked.
|
Premature Program Termination | View Details |
| – |
Steam or water leaks from the side of the lid or around the hinge during pressure cooking.
|
Lid Deformation / Hinge Misalignment | View Details |
| – |
Unusual rattling, clicking, or buzzing noises from the base during operation.
|
Mechanical Vibration / Loose Components | View Details |
| – |
Water or foam spurts from the steam release valve during pressure cooking.
|
Foaming / Overfilled Pot | View Details |
No matching codes found
Advertisements