Vorwerk Multicookers Error Codes

C141

Multicooker (e.g. Thermomix TM5/TM6) displays C141 and will not start heating or mixing

Motor Overload / Overcurrent Protection Triggered

C142

C142 error appears and the multicooker stops, often during heavy dough or chopping tasks

Motor Temperature Overheat Protection

C143

C143 error, appliance refuses to start motor even with empty bowl

Motor Tachometer / Speed Feedback Fault

C144

C144 error appears when trying to start a program; motor does not run

Motor Blocked / Mechanical Jam Detected

C145

C145 error during operation, often accompanied by unusual grinding or rattling noises

Drive Coupling / Gearbox Slippage

C150

C150 error appears and heating stops; display may mention temperature sensor

Bowl Temperature Sensor (NTC) Fault

C151

C151 error, appliance cannot control temperature correctly (overheats or does not heat)

Heating System Control Fault

C152

C152 error appears when starting a cooking program; unit may heat unexpectedly or not at all

Secondary Temperature Sensor / Overheat Sensor Fault

C160

C160 error, appliance refuses to start any program; often described as lid not detected

Lid Lock / Lid Detection Fault

C161

C161 error, lid cannot be locked or unlocked; appliance may remain locked after program

Lid Lock Actuator Fault

C170

C170 error, appliance reports scale or boiling detection issue; heating may be limited

Boil Detection / Power Limitation Due to Scaling

C190

C190 error, appliance reports internal communication error and stops

Internal Communication Bus Fault

C191

C191 error, touchscreen or display becomes unresponsive or shows communication error

Display / Touchscreen Module Communication Fault

C200

C200 error, appliance reports scale or cleaning required; heating performance reduced

Scaling / Maintenance Warning

C210

C210 error, appliance reports overfill or safety overflow condition

Overfill / Overflow Sensor Triggered

C220

C220 error, appliance reports scale or contamination in steam system (for models with steaming accessories)

Steam System Scaling / Sensor Contamination

C230

C230 error, appliance reports internal fan or cooling problem

Electronics Cooling Fan Fault

C240

C240 error, appliance reports power supply or voltage issue

Input Power / Power Supply Fault

C250

C250 error, appliance reports memory or configuration error

Non-Volatile Memory / Configuration Fault

C260

C260 error, appliance reports scale or contamination in weighing system (for models with integrated scale)

Integrated Scale Sensor Fault

C270

C270 error, appliance reports accessory detection problem (e.g., Varoma, mixing bowl, or lid not recognized)

Accessory Detection Sensor Fault

C280

C280 error, appliance reports internal sensor mismatch or calibration error

Sensor Calibration / Consistency Fault

Symptom

Accessories such as Varoma or simmering basket do not fit securely or wobble

Accessory Fitment / Wear Issue

Symptom

Appliance heats but does not mix (heating works, knife does not turn)

Drive Train / Motor Transmission Failure

Symptom

Appliance mixes but does not heat (temperature stays low even when set high)

Heating Element or Temperature Control Failure

Symptom

Burning smell during operation, with or without visible smoke

Overheating or Electrical Insulation Breakdown

Symptom

Condensation or water droplets visible inside the base or around vents

Moisture Ingress / Condensation

Symptom

Excessive vibration or the appliance "walks" on the countertop during operation

Imbalance / Vibration Control Issue

Symptom

Food consistently burns or sticks to the bottom of the bowl

Localized Overheating / Temperature Control Deviation

Symptom

Integrated scale gives inconsistent or obviously wrong weight readings

Scale Miscalibration or Mechanical Interference

Symptom

Leaking from the bottom of the bowl onto the base

Bowl Seal / Knife Gasket Failure

Symptom

Lid is difficult to open or close, even when appliance is cool and unlocked

Mechanical Binding in Lid or Locking Arms

Symptom

Loud knocking, grinding, or rattling noise during mixing or kneading

Mechanical Wear in Mixing Knife or Gearbox

Symptom

Multicooker does not power on at all (no lights, no display)

No Power / Dead Appliance

Symptom

Multicooker powers on but will not start any program (Start button greyed out or error about lid/bowl)

Start Interlock / Safety System Not Satisfied

Symptom

Programs stop prematurely without error, or appliance restarts during cooking

Intermittent Power or Control Reset

Symptom

Steam or liquid leaking from around the lid during cooking

Lid Seal / Gasket Failure

Symptom

Strong unpleasant odor from inside the bowl or lid even after normal washing

Odor Retention / Bacterial Growth

Symptom

Touchscreen or buttons intermittently unresponsive, but no specific error code

User Interface Input Fault

Symptom

Unusual electrical buzzing or humming from the base, louder than normal

Power Electronics or Motor Drive Noise

Symptom

Visible cracks or discoloration in the mixing bowl

Bowl Structural Damage