BODEGA43
BODEGA43 Wine Coolers Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
dE
Display shows dE and the interior light or fans may turn off unexpectedly; unit may think the door is open when it is closed.
Door Switch or Door Sensor Fault
E1
Digital display shows E1 and cabinet temperature is not matching the set temperature; unit may run continuously or short-cycle.
Cabinet Temperature Sensor (NTC) Failure
E2
Display shows E2 and the compressor or fan may not run correctly; temperature drifts or one zone is much warmer than expected.
Evaporator Temperature Sensor Failure
E3
Display shows E3 and the ambient temperature reading is incorrect or the unit behaves erratically in warm or cold rooms.
Ambient Temperature Sensor Failure
E4
Display shows E4 and the unit may not defrost properly; heavy ice buildup on the evaporator or frequent temperature swings.
Defrost Sensor or Defrost Circuit Fault
E5
Display shows E5 and the compressor may not start, or starts briefly and shuts off; cabinet warms up.
Compressor Overload or Start Protection Fault
E6
Display shows E6 and the interior fan may not run; uneven temperature or warm spots inside the cabinet.
Evaporator Fan Motor Fault
E7
Display shows E7 and the condenser fan at the rear of the unit does not run or runs erratically; compressor may overheat.
Condenser Fan Motor Fault
E8
Display shows E8 and the unit may not cool; compressor does not start even though the display appears normal.
Compressor Drive or Main Control Board Fault
E9
Display shows E9 and the interior light or touch controls behave erratically; sometimes the display flickers or buttons do not respond.
User Interface / Display Board Communication Fault
Er
Display shows Er or generic error and the unit may not respond to temperature changes.
General Control System Error
H1
Display shows H1 and the cabinet temperature is much higher than the setpoint; unit may run continuously.
High Temperature Alarm Condition
L1
Display shows L1 and the cabinet temperature is much lower than the setpoint; bottles may be too cold.
Low Temperature Alarm / Overcooling
Lo
Display shows Lo and the set temperature cannot be adjusted lower; unit may be in a lock or child-lock mode.
Control Panel Lock / Keypad Lock Condition
Symptom
Clicking sound from the rear of the unit every few minutes; compressor tries to start but fails.
Compressor Start Failure
Symptom
Compressor and fans do not run, but the display and interior light work normally.
Cooling System Disabled While Control Powered
Symptom
Condensation or water droplets forming on the inside of the glass door.
Door Condensation / Gasket Leak
Symptom
Displayed temperature is significantly different from the actual temperature measured with a thermometer.
Temperature Calibration / Sensor Drift
Symptom
Door does not close properly or pops open slightly after being shut.
Door Alignment / Hinge Problem
Symptom
Dual-zone BODEGA43 wine cooler: upper zone cools but lower zone is warm (or vice versa).
Single-Zone Cooling Failure in Dual-Zone Unit
Symptom
Frost or ice buildup on the back wall or around the evaporator area inside the cabinet.
Excessive Frost Accumulation
Symptom
High-pitched squealing or grinding noise from inside the cabinet when cooling.
Evaporator Fan Bearing Wear
Symptom
Interior light does not turn on when the door is opened, but cooling works normally.
Interior LED Lighting Failure
Symptom
Interior light stays on even when the door is closed, causing extra heat inside the cabinet.
Stuck Door Switch / Light Control Fault
Symptom
Persistent musty or moldy odor inside the cabinet even after cleaning.
Internal Odor / Microbial Growth
Symptom
Shelves are difficult to slide in and out or feel loose and unstable.
Shelf / Rack Fitment Issue
Symptom
Strong chemical or burning smell coming from the rear of the wine cooler.
Overheating Electrical Component
Symptom
Touch buttons on the control panel do not respond or respond intermittently.
Unresponsive Touch Control Panel
Symptom
Unit cycles on and off frequently with short run times, and temperature fluctuates.
Short Cycling
Symptom
Unit trips the household circuit breaker or GFCI outlet when it starts.
Electrical Short or Ground Fault
Symptom
Water pooling at the bottom of the cabinet or leaking onto the floor in front of the wine cooler.
Drainage / Condensate Leak
Symptom
Wine cooler does not power on at all; display is dark and no fans or compressor noise.
No Power / Dead Appliance
Symptom
Wine cooler is too cold; bottles or labels show signs of condensation freezing or partial ice formation.
Overcooling Without Error Code
Symptom
Wine cooler makes loud rattling or vibrating noises during operation.
Excessive Vibration / Mechanical Noise
Symptom
Wine cooler runs but does not get cold enough; temperature remains above setpoint by several degrees.
Insufficient Cooling Performance
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| dE |
Display shows dE and the interior light or fans may turn off unexpectedly; unit may think the door is open when it is closed.
|
Door Switch or Door Sensor Fault | View Details |
| E1 |
Digital display shows E1 and cabinet temperature is not matching the set temperature; unit may run continuously or short-cycle.
|
Cabinet Temperature Sensor (NTC) Failure | View Details |
| E2 |
Display shows E2 and the compressor or fan may not run correctly; temperature drifts or one zone is much warmer than expected.
|
Evaporator Temperature Sensor Failure | View Details |
| E3 |
Display shows E3 and the ambient temperature reading is incorrect or the unit behaves erratically in warm or cold rooms.
|
Ambient Temperature Sensor Failure | View Details |
| E4 |
Display shows E4 and the unit may not defrost properly; heavy ice buildup on the evaporator or frequent temperature swings.
|
Defrost Sensor or Defrost Circuit Fault | View Details |
| E5 |
Display shows E5 and the compressor may not start, or starts briefly and shuts off; cabinet warms up.
|
Compressor Overload or Start Protection Fault | View Details |
| E6 |
Display shows E6 and the interior fan may not run; uneven temperature or warm spots inside the cabinet.
|
Evaporator Fan Motor Fault | View Details |
| E7 |
Display shows E7 and the condenser fan at the rear of the unit does not run or runs erratically; compressor may overheat.
|
Condenser Fan Motor Fault | View Details |
| E8 |
Display shows E8 and the unit may not cool; compressor does not start even though the display appears normal.
|
Compressor Drive or Main Control Board Fault | View Details |
| E9 |
Display shows E9 and the interior light or touch controls behave erratically; sometimes the display flickers or buttons do not respond.
|
User Interface / Display Board Communication Fault | View Details |
| Er |
Display shows Er or generic error and the unit may not respond to temperature changes.
|
General Control System Error | View Details |
| H1 |
Display shows H1 and the cabinet temperature is much higher than the setpoint; unit may run continuously.
|
High Temperature Alarm Condition | View Details |
| L1 |
Display shows L1 and the cabinet temperature is much lower than the setpoint; bottles may be too cold.
|
Low Temperature Alarm / Overcooling | View Details |
| Lo |
Display shows Lo and the set temperature cannot be adjusted lower; unit may be in a lock or child-lock mode.
|
Control Panel Lock / Keypad Lock Condition | View Details |
| – |
Clicking sound from the rear of the unit every few minutes; compressor tries to start but fails.
|
Compressor Start Failure | View Details |
| – |
Compressor and fans do not run, but the display and interior light work normally.
|
Cooling System Disabled While Control Powered | View Details |
| – |
Condensation or water droplets forming on the inside of the glass door.
|
Door Condensation / Gasket Leak | View Details |
| – |
Displayed temperature is significantly different from the actual temperature measured with a thermometer.
|
Temperature Calibration / Sensor Drift | View Details |
| – |
Door does not close properly or pops open slightly after being shut.
|
Door Alignment / Hinge Problem | View Details |
| – |
Dual-zone BODEGA43 wine cooler: upper zone cools but lower zone is warm (or vice versa).
|
Single-Zone Cooling Failure in Dual-Zone Unit | View Details |
| – |
Frost or ice buildup on the back wall or around the evaporator area inside the cabinet.
|
Excessive Frost Accumulation | View Details |
| – |
High-pitched squealing or grinding noise from inside the cabinet when cooling.
|
Evaporator Fan Bearing Wear | View Details |
| – |
Interior light does not turn on when the door is opened, but cooling works normally.
|
Interior LED Lighting Failure | View Details |
| – |
Interior light stays on even when the door is closed, causing extra heat inside the cabinet.
|
Stuck Door Switch / Light Control Fault | View Details |
| – |
Persistent musty or moldy odor inside the cabinet even after cleaning.
|
Internal Odor / Microbial Growth | View Details |
| – |
Shelves are difficult to slide in and out or feel loose and unstable.
|
Shelf / Rack Fitment Issue | View Details |
| – |
Strong chemical or burning smell coming from the rear of the wine cooler.
|
Overheating Electrical Component | View Details |
| – |
Touch buttons on the control panel do not respond or respond intermittently.
|
Unresponsive Touch Control Panel | View Details |
| – |
Unit cycles on and off frequently with short run times, and temperature fluctuates.
|
Short Cycling | View Details |
| – |
Unit trips the household circuit breaker or GFCI outlet when it starts.
|
Electrical Short or Ground Fault | View Details |
| – |
Water pooling at the bottom of the cabinet or leaking onto the floor in front of the wine cooler.
|
Drainage / Condensate Leak | View Details |
| – |
Wine cooler does not power on at all; display is dark and no fans or compressor noise.
|
No Power / Dead Appliance | View Details |
| – |
Wine cooler is too cold; bottles or labels show signs of condensation freezing or partial ice formation.
|
Overcooling Without Error Code | View Details |
| – |
Wine cooler makes loud rattling or vibrating noises during operation.
|
Excessive Vibration / Mechanical Noise | View Details |
| – |
Wine cooler runs but does not get cold enough; temperature remains above setpoint by several degrees.
|
Insufficient Cooling Performance | View Details |
No matching codes found
Advertisements