SEBO
SEBO Cordless Vacuums Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
E1
Cordless SEBO vacuum will not start; red fault indicator flashes once repeatedly after power button is pressed.
Main Power Circuit Fault
E10
Cordless SEBO vacuum indicates ten red flashes; unit may run only at low power or not at all.
Sensor Fault (Temperature, Hall Sensor, or Position Sensor)
E2
Cordless SEBO vacuum stops shortly after starting; red fault indicator flashes twice in a repeating pattern.
Motor Overcurrent / Motor Short Fault
E3
Cordless SEBO vacuum runs but shuts off when brush mode is engaged; red fault indicator flashes three times repeatedly.
Brush Motor Overload / Brush Jam Fault
E4
Cordless SEBO vacuum shows four red flashes and will not run; may occur immediately after a blockage or overheating event.
Thermal Overload / Overheating Protection
E5
Cordless SEBO vacuum will not accept charge; charger LED blinks error pattern and vacuum indicator shows five flashes when battery is inserted.
Battery Pack Communication / Identification Fault
E6
Cordless SEBO vacuum shuts down under load; red indicator flashes six times; unit may run briefly with no brush or low suction.
Overcurrent Protection / Short in Brush or Motor Circuit
E7
Cordless SEBO vacuum shows seven red flashes and does not start; often after long storage or deep discharge.
Battery Undervoltage Lockout
E8
Cordless SEBO vacuum displays eight red flashes and refuses to run; may occur immediately after inserting battery.
Battery Overvoltage / Incompatible Pack Fault
E9
Cordless SEBO vacuum shows nine red flashes; unit may start then immediately stop with no suction or brush movement.
Internal Communication Error (Battery–Main PCB or PCB–Brush Head)
Symptom
Cordless SEBO vacuum battery will not charge; charger light stays off or blinks rapidly and vacuum never gains runtime.
Charging Failure
Symptom
Cordless SEBO vacuum brush spins but stops when pushed onto carpet, then restarts when lifted.
Brush Overload Protection Triggering
Symptom
Cordless SEBO vacuum dust bin is difficult to remove or reinstall.
Dust Bin Latch or Alignment Issue
Symptom
Cordless SEBO vacuum emits a burning smell or hot plastic odor during use.
Overheating Motor or Brush Drive
Symptom
Cordless SEBO vacuum floor head is difficult to push on carpet or feels like it is sticking to the floor.
Excessive Brush or Suction Drag
Symptom
Cordless SEBO vacuum handle or body feels loose or flexes excessively during use.
Structural Loosening / Housing Damage
Symptom
Cordless SEBO vacuum hinge or folding mechanism feels loose or does not lock in upright position.
Pivot / Hinge Lock Wear
Symptom
Cordless SEBO vacuum is excessively loud compared to normal operation, even with clean filters.
Motor Bearing Wear / Fan Damage
Symptom
Cordless SEBO vacuum leaves debris on carpet; brush spins intermittently or stops under light load.
Brush Drive Slipping / Weak Agitation
Symptom
Cordless SEBO vacuum leaves fine dust haze or odor in the air; allergy symptoms worsen during use.
Poor Filtration / Exhaust Leak
Symptom
Cordless SEBO vacuum lights (headlights or indicator LEDs) flicker during use.
Unstable Power Supply to LEDs
Symptom
Cordless SEBO vacuum loses connection to powered accessories (e.g., motorized mini brush) intermittently.
Accessory Power/Signal Interruption
Symptom
Cordless SEBO vacuum makes a high-pitched whistling noise during use.
Air Leak in Suction Path
Symptom
Cordless SEBO vacuum makes loud rattling or grinding noises from the brush head.
Brush Head Mechanical Damage
Symptom
Cordless SEBO vacuum mode selector (power level or brush on/off) does not change settings.
Control Interface Failure
Symptom
Cordless SEBO vacuum power button is unresponsive or sticks in one position.
Power Switch Mechanical/Electrical Failure
Symptom
Cordless SEBO vacuum produces a musty or unpleasant odor when running.
Contaminated Air Path / Biological Growth
Symptom
Cordless SEBO vacuum produces static shocks to the user during operation, especially on dry carpets.
Static Electricity Buildup
Symptom
Cordless SEBO vacuum runs but suction is very weak compared to normal.
Low Suction / Airflow Restriction
Symptom
Cordless SEBO vacuum runs but the brush does not spin at all on carpet or hard floors.
Brush Motor or Drive Failure
Symptom
Cordless SEBO vacuum runs but then suddenly stops and all lights go out, as if the battery was removed.
Battery Connection Interruption
Symptom
Cordless SEBO vacuum runs for only a few minutes on a full charge before shutting off.
Severely Reduced Battery Capacity
Symptom
Cordless SEBO vacuum shuts off randomly during use and restarts after a short rest.
Intermittent Thermal Cutout or Loose Connection
Symptom
Cordless SEBO vacuum wand or extension tube repeatedly separates from the main body or floor head during use.
Wand Locking Mechanism Wear
Symptom
Cordless SEBO vacuum will not turn on at all; no lights, no sound, even with charger connected.
Complete Power Loss
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| E1 |
Cordless SEBO vacuum will not start; red fault indicator flashes once repeatedly after power button is pressed.
|
Main Power Circuit Fault | View Details |
| E10 |
Cordless SEBO vacuum indicates ten red flashes; unit may run only at low power or not at all.
|
Sensor Fault (Temperature, Hall Sensor, or Position Sensor) | View Details |
| E2 |
Cordless SEBO vacuum stops shortly after starting; red fault indicator flashes twice in a repeating pattern.
|
Motor Overcurrent / Motor Short Fault | View Details |
| E3 |
Cordless SEBO vacuum runs but shuts off when brush mode is engaged; red fault indicator flashes three times repeatedly.
|
Brush Motor Overload / Brush Jam Fault | View Details |
| E4 |
Cordless SEBO vacuum shows four red flashes and will not run; may occur immediately after a blockage or overheating event.
|
Thermal Overload / Overheating Protection | View Details |
| E5 |
Cordless SEBO vacuum will not accept charge; charger LED blinks error pattern and vacuum indicator shows five flashes when battery is inserted.
|
Battery Pack Communication / Identification Fault | View Details |
| E6 |
Cordless SEBO vacuum shuts down under load; red indicator flashes six times; unit may run briefly with no brush or low suction.
|
Overcurrent Protection / Short in Brush or Motor Circuit | View Details |
| E7 |
Cordless SEBO vacuum shows seven red flashes and does not start; often after long storage or deep discharge.
|
Battery Undervoltage Lockout | View Details |
| E8 |
Cordless SEBO vacuum displays eight red flashes and refuses to run; may occur immediately after inserting battery.
|
Battery Overvoltage / Incompatible Pack Fault | View Details |
| E9 |
Cordless SEBO vacuum shows nine red flashes; unit may start then immediately stop with no suction or brush movement.
|
Internal Communication Error (Battery–Main PCB or PCB–Brush Head) | View Details |
| – |
Cordless SEBO vacuum battery will not charge; charger light stays off or blinks rapidly and vacuum never gains runtime.
|
Charging Failure | View Details |
| – |
Cordless SEBO vacuum brush spins but stops when pushed onto carpet, then restarts when lifted.
|
Brush Overload Protection Triggering | View Details |
| – |
Cordless SEBO vacuum dust bin is difficult to remove or reinstall.
|
Dust Bin Latch or Alignment Issue | View Details |
| – |
Cordless SEBO vacuum emits a burning smell or hot plastic odor during use.
|
Overheating Motor or Brush Drive | View Details |
| – |
Cordless SEBO vacuum floor head is difficult to push on carpet or feels like it is sticking to the floor.
|
Excessive Brush or Suction Drag | View Details |
| – |
Cordless SEBO vacuum handle or body feels loose or flexes excessively during use.
|
Structural Loosening / Housing Damage | View Details |
| – |
Cordless SEBO vacuum hinge or folding mechanism feels loose or does not lock in upright position.
|
Pivot / Hinge Lock Wear | View Details |
| – |
Cordless SEBO vacuum is excessively loud compared to normal operation, even with clean filters.
|
Motor Bearing Wear / Fan Damage | View Details |
| – |
Cordless SEBO vacuum leaves debris on carpet; brush spins intermittently or stops under light load.
|
Brush Drive Slipping / Weak Agitation | View Details |
| – |
Cordless SEBO vacuum leaves fine dust haze or odor in the air; allergy symptoms worsen during use.
|
Poor Filtration / Exhaust Leak | View Details |
| – |
Cordless SEBO vacuum lights (headlights or indicator LEDs) flicker during use.
|
Unstable Power Supply to LEDs | View Details |
| – |
Cordless SEBO vacuum loses connection to powered accessories (e.g., motorized mini brush) intermittently.
|
Accessory Power/Signal Interruption | View Details |
| – |
Cordless SEBO vacuum makes a high-pitched whistling noise during use.
|
Air Leak in Suction Path | View Details |
| – |
Cordless SEBO vacuum makes loud rattling or grinding noises from the brush head.
|
Brush Head Mechanical Damage | View Details |
| – |
Cordless SEBO vacuum mode selector (power level or brush on/off) does not change settings.
|
Control Interface Failure | View Details |
| – |
Cordless SEBO vacuum power button is unresponsive or sticks in one position.
|
Power Switch Mechanical/Electrical Failure | View Details |
| – |
Cordless SEBO vacuum produces a musty or unpleasant odor when running.
|
Contaminated Air Path / Biological Growth | View Details |
| – |
Cordless SEBO vacuum produces static shocks to the user during operation, especially on dry carpets.
|
Static Electricity Buildup | View Details |
| – |
Cordless SEBO vacuum runs but suction is very weak compared to normal.
|
Low Suction / Airflow Restriction | View Details |
| – |
Cordless SEBO vacuum runs but the brush does not spin at all on carpet or hard floors.
|
Brush Motor or Drive Failure | View Details |
| – |
Cordless SEBO vacuum runs but then suddenly stops and all lights go out, as if the battery was removed.
|
Battery Connection Interruption | View Details |
| – |
Cordless SEBO vacuum runs for only a few minutes on a full charge before shutting off.
|
Severely Reduced Battery Capacity | View Details |
| – |
Cordless SEBO vacuum shuts off randomly during use and restarts after a short rest.
|
Intermittent Thermal Cutout or Loose Connection | View Details |
| – |
Cordless SEBO vacuum wand or extension tube repeatedly separates from the main body or floor head during use.
|
Wand Locking Mechanism Wear | View Details |
| – |
Cordless SEBO vacuum will not turn on at all; no lights, no sound, even with charger connected.
|
Complete Power Loss | View Details |
No matching codes found
Advertisements