Midea Washer-Dryer Combos Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
E1
Washer-dryer combo will not fill with water; display shows E1 shortly after cycle start.
Water Inlet Timeout / No Fill
E10
Washer-dryer combo shows E10 and will not start or stops unexpectedly; control panel may be unresponsive.
Communication Error Between Main PCB and Interface Board
E11
Washer-dryer combo displays E11 and the door will not lock or the cycle will not start.
Door Lock Circuit Fault
E12
Washer-dryer combo shows E12 and drying function does not start or stops quickly.
Dryer Fan / Blower Fault
E13
Washer-dryer combo displays E13 and may stop during drying; unit may feel excessively hot.
Dryer Overheating / Thermal Cutout
E2
Washer-dryer combo does not drain water; drum remains full and E2 is displayed.
Drain Timeout / No Drain
E21
Washer-dryer combo shows E21 and will not drain or complete cycles.
Secondary Drain Error / Pump Blockage
E23
Washer-dryer combo displays E23 and may not drain or may show intermittent drain issues.
Drain Pump Triac / Control Fault
E3
Washer-dryer combo shows E3 and stops during spin; drum may be heavily loaded or unbalanced.
Unbalanced Load / Spin Protection
E30
Washer-dryer combo shows E30 and will not start or stops mid-cycle; door may remain locked.
Door Lock Detection Error
E31
Washer-dryer combo displays E31 and may not fill or may overfill; water level readings are erratic.
Pressure Sensor Calibration / Signal Error
E32
Washer-dryer combo shows E32 and may not spin properly; speed control seems unstable.
Motor Tachometer / Speed Feedback Error
E33
Washer-dryer combo displays E33 and may stop with water in the drum or show inconsistent water levels.
Pressure System Inconsistency (Overflow vs. Empty Signals)
E4
Washer-dryer combo displays E4 and may vibrate excessively or fail to reach full spin speed.
Excessive Vibration / Out-of-Balance Detection
E40
Washer-dryer combo shows E40 and will not start; door symbol may flash.
Door Not Properly Closed
E41
Washer-dryer combo displays E41 and may unlock the door unexpectedly or refuse to lock.
Door Lock Signal Error (Open Signal When Should Be Closed)
E5
Washer-dryer combo shows E5 and does not heat water during wash; cycles may run cold.
Water Heating Failure
E50
Washer-dryer combo shows E50 and may not spin or wash; motor operation is erratic.
General Motor Error
E51
Washer-dryer combo displays E51 and may trip the breaker or fail to start motor.
Motor Triac Short / Power Device Failure
E6
Washer-dryer combo shows E6 and will not spin or wash; motor does not run.
Motor Drive Fault
E60
Washer-dryer combo shows E60 and drying performance is poor or absent.
General Dryer Heating Error
E61
Washer-dryer combo displays E61 and may overheat during drying or shut down prematurely.
Dryer Temperature Control Error
E7
Washer-dryer combo displays E7 and may stop mid-cycle; water level appears incorrect or fluctuating.
Water Level Sensor (Pressure Switch) Fault
E8
Washer-dryer combo shows E8 and may not heat or may overheat during drying.
Dryer Temperature Sensor / NTC Fault
E9
Washer-dryer combo displays E9 and may stop with water still in the drum or show erratic water levels.
Water Overflow / Overfill Protection
E90
Washer-dryer combo shows E90 and all functions may be disabled; display may flicker or show random symbols.
Configuration / Communication Error
Symptom
Washer-dryer combo does not dispense detergent or softener from the drawer.
Dispenser Drawer Blockage
Symptom
Washer-dryer combo door remains locked after cycle ends and cannot be opened.
Door Lock Stuck Closed
Symptom
Washer-dryer combo drum does not turn during wash or spin, but you can hear the motor humming.
Drive Belt Slipped or Broken
Symptom
Washer-dryer combo drum is difficult to turn by hand and makes scraping noises.
Foreign Object Between Drum and Tub
Symptom
Washer-dryer combo emits a burning smell during drying or high-temperature washes.
Overheating / Lint or Electrical Smell
Symptom
Washer-dryer combo emits a high-pitched squeal or grinding noise when spinning.
Drum Bearing or Drive Belt Wear
Symptom
Washer-dryer combo leaks water from the front under the door during wash cycles.
Door Gasket (Boot Seal) Leak
Symptom
Washer-dryer combo leaks water from the rear or bottom during wash or drain.
Tub-to-Pump Hose or Drain Hose Leak
Symptom
Washer-dryer combo leaves clothes very wet at the end of the cycle.
Poor Spin Performance
Symptom
Washer-dryer combo leaves visible detergent residue or white streaks on clothes.
Poor Rinsing / Detergent Overuse
Symptom
Washer-dryer combo makes loud banging or knocking noises during spin.
Suspension / Shock Absorber Wear
Symptom
Washer-dryer combo produces a musty or moldy odor inside the drum and on clothes.
Biofilm / Mold Growth in Drum and Hoses
Symptom
Washer-dryer combo shows condensation or water droplets on the control panel and around the door after drying.
Normal Condensation / Ventilation Issue
Symptom
Washer-dryer combo takes excessively long to dry clothes or never fully dries them.
Poor Drying Performance
Symptom
Washer-dryer combo vibrates excessively and walks across the floor during spin.
Installation / Leveling Issue
Symptom
Washer-dryer combo will not power on; display is completely dead.
No Power / Main Supply Fault
Symptom
Washer-dryer combo will not start any cycle; panel lights but Start button does nothing.
User Interface / Control Lock Issue
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| E1 |
Washer-dryer combo will not fill with water; display shows E1 shortly after cycle start.
|
Water Inlet Timeout / No Fill | View Details |
| E10 |
Washer-dryer combo shows E10 and will not start or stops unexpectedly; control panel may be unresponsive.
|
Communication Error Between Main PCB and Interface Board | View Details |
| E11 |
Washer-dryer combo displays E11 and the door will not lock or the cycle will not start.
|
Door Lock Circuit Fault | View Details |
| E12 |
Washer-dryer combo shows E12 and drying function does not start or stops quickly.
|
Dryer Fan / Blower Fault | View Details |
| E13 |
Washer-dryer combo displays E13 and may stop during drying; unit may feel excessively hot.
|
Dryer Overheating / Thermal Cutout | View Details |
| E2 |
Washer-dryer combo does not drain water; drum remains full and E2 is displayed.
|
Drain Timeout / No Drain | View Details |
| E21 |
Washer-dryer combo shows E21 and will not drain or complete cycles.
|
Secondary Drain Error / Pump Blockage | View Details |
| E23 |
Washer-dryer combo displays E23 and may not drain or may show intermittent drain issues.
|
Drain Pump Triac / Control Fault | View Details |
| E3 |
Washer-dryer combo shows E3 and stops during spin; drum may be heavily loaded or unbalanced.
|
Unbalanced Load / Spin Protection | View Details |
| E30 |
Washer-dryer combo shows E30 and will not start or stops mid-cycle; door may remain locked.
|
Door Lock Detection Error | View Details |
| E31 |
Washer-dryer combo displays E31 and may not fill or may overfill; water level readings are erratic.
|
Pressure Sensor Calibration / Signal Error | View Details |
| E32 |
Washer-dryer combo shows E32 and may not spin properly; speed control seems unstable.
|
Motor Tachometer / Speed Feedback Error | View Details |
| E33 |
Washer-dryer combo displays E33 and may stop with water in the drum or show inconsistent water levels.
|
Pressure System Inconsistency (Overflow vs. Empty Signals) | View Details |
| E4 |
Washer-dryer combo displays E4 and may vibrate excessively or fail to reach full spin speed.
|
Excessive Vibration / Out-of-Balance Detection | View Details |
| E40 |
Washer-dryer combo shows E40 and will not start; door symbol may flash.
|
Door Not Properly Closed | View Details |
| E41 |
Washer-dryer combo displays E41 and may unlock the door unexpectedly or refuse to lock.
|
Door Lock Signal Error (Open Signal When Should Be Closed) | View Details |
| E5 |
Washer-dryer combo shows E5 and does not heat water during wash; cycles may run cold.
|
Water Heating Failure | View Details |
| E50 |
Washer-dryer combo shows E50 and may not spin or wash; motor operation is erratic.
|
General Motor Error | View Details |
| E51 |
Washer-dryer combo displays E51 and may trip the breaker or fail to start motor.
|
Motor Triac Short / Power Device Failure | View Details |
| E6 |
Washer-dryer combo shows E6 and will not spin or wash; motor does not run.
|
Motor Drive Fault | View Details |
| E60 |
Washer-dryer combo shows E60 and drying performance is poor or absent.
|
General Dryer Heating Error | View Details |
| E61 |
Washer-dryer combo displays E61 and may overheat during drying or shut down prematurely.
|
Dryer Temperature Control Error | View Details |
| E7 |
Washer-dryer combo displays E7 and may stop mid-cycle; water level appears incorrect or fluctuating.
|
Water Level Sensor (Pressure Switch) Fault | View Details |
| E8 |
Washer-dryer combo shows E8 and may not heat or may overheat during drying.
|
Dryer Temperature Sensor / NTC Fault | View Details |
| E9 |
Washer-dryer combo displays E9 and may stop with water still in the drum or show erratic water levels.
|
Water Overflow / Overfill Protection | View Details |
| E90 |
Washer-dryer combo shows E90 and all functions may be disabled; display may flicker or show random symbols.
|
Configuration / Communication Error | View Details |
| – |
Washer-dryer combo does not dispense detergent or softener from the drawer.
|
Dispenser Drawer Blockage | View Details |
| – |
Washer-dryer combo door remains locked after cycle ends and cannot be opened.
|
Door Lock Stuck Closed | View Details |
| – |
Washer-dryer combo drum does not turn during wash or spin, but you can hear the motor humming.
|
Drive Belt Slipped or Broken | View Details |
| – |
Washer-dryer combo drum is difficult to turn by hand and makes scraping noises.
|
Foreign Object Between Drum and Tub | View Details |
| – |
Washer-dryer combo emits a burning smell during drying or high-temperature washes.
|
Overheating / Lint or Electrical Smell | View Details |
| – |
Washer-dryer combo emits a high-pitched squeal or grinding noise when spinning.
|
Drum Bearing or Drive Belt Wear | View Details |
| – |
Washer-dryer combo leaks water from the front under the door during wash cycles.
|
Door Gasket (Boot Seal) Leak | View Details |
| – |
Washer-dryer combo leaks water from the rear or bottom during wash or drain.
|
Tub-to-Pump Hose or Drain Hose Leak | View Details |
| – |
Washer-dryer combo leaves clothes very wet at the end of the cycle.
|
Poor Spin Performance | View Details |
| – |
Washer-dryer combo leaves visible detergent residue or white streaks on clothes.
|
Poor Rinsing / Detergent Overuse | View Details |
| – |
Washer-dryer combo makes loud banging or knocking noises during spin.
|
Suspension / Shock Absorber Wear | View Details |
| – |
Washer-dryer combo produces a musty or moldy odor inside the drum and on clothes.
|
Biofilm / Mold Growth in Drum and Hoses | View Details |
| – |
Washer-dryer combo shows condensation or water droplets on the control panel and around the door after drying.
|
Normal Condensation / Ventilation Issue | View Details |
| – |
Washer-dryer combo takes excessively long to dry clothes or never fully dries them.
|
Poor Drying Performance | View Details |
| – |
Washer-dryer combo vibrates excessively and walks across the floor during spin.
|
Installation / Leveling Issue | View Details |
| – |
Washer-dryer combo will not power on; display is completely dead.
|
No Power / Main Supply Fault | View Details |
| – |
Washer-dryer combo will not start any cycle; panel lights but Start button does nothing.
|
User Interface / Control Lock Issue | View Details |
No matching codes found
Advertisements